Description
Alternator charger for charging a power station while driving
The FOSSiBOT FAC580 alternator charger draws energy from the vehicle’s electrical system and uses it to charge a portable power station while driving. Charging efficiency is 92%. According to the manufacturer, the FAC580 charges up to 6 times faster than a standard 96 W car socket.

Two operating modes for driving and for a parked car
The switch button turns the charger on and selects the mode. Mode I for charging while driving works at 13–18 V or 24–33 V input: at 13.2–14 V it delivers up to 300 W and above 14 V up to 580 W; below 13.2 V charging stops. Emergency mode II works with the engine off, delivers up to 300 W at 12–12.75 V and up to 580 W above 12.75 V, and switches the output off below 12 V to protect the car battery from deep discharge.

Protection and cooling
The charger has over- and undervoltage protection plus protection against overcurrent, short circuit, reverse polarity and excessive or low temperature. When a protection trips, the output switches off, the indicator flashes red and a buzzer sounds; after a voltage fault, charging resumes once the voltage is normal again. A left-hand fan and a right-hand vent remove heat; above 45 °C the output power is halved.
Compatibility with power stations
The FAC580 works with all FOSSiBOT power stations and with other makers’ power stations whose maximum charging voltage is at least 45 V. The charging power is the lower of the charger’s 580 W and the power station’s permitted charging power.
Installation in the vehicle
The charger is designed for vehicles with a 12 V or 24 V battery. Fix it with screws to the side wall of the boot and keep at least 5 cm clear in front of the vents. The input terminals connect to the car battery with the 5 m cable and the output terminals to the power station with the 0.5 m cable, with the vehicle switched off during installation.

What’s in the box
- FOSSiBOT FAC580 alternator charger, 1 pc
- Input cable for the car battery, 5 m, 1 pc
- Output cable for the power station, 0.5 m, 1 pc
- Screws, 6 pcs
- Terminal caps, 4 pcs
- Screwdriver, 1 pc
- User manual


Reviews
There are no reviews yet.