Description
Open-blade T-blade trimmer for cutting outlines
T-blade trimmer BaByliss PRO GoldFX SkeletonFX FX7870GE is designed for cutting outlines, and its 40 mm wide blade is fully open from the housing. The open blade is visible from every direction (360°) and is driven by the electronically controlled EDM TECHNOLOGY motor at a speed of 7200 cutting strokes per minute.
Battery and charging
Before first use, charge the trimmer for 3 hours in one go: the lithium-ion battery reaches its maximum capacity after 3 charge and discharge cycles. The red indicator light flashes while charging and stays on steadily when the battery is full. A quickly flashing red light shows that there is still about 10 minutes of battery left. To keep the battery in good condition, charge the trimmer for 3 hours about every 6 months.
Setting the blade zero gap
With the tool included in the set, you can set the blade to a zero gap, so that the cut is shorter and more precise. To do this, loosen the blade screws with a screwdriver, slide the tool onto the gold fixed blade, and push the black moving blade flush with the fixed blade or slightly below it. The teeth of the moving blade must sit 0.5–1 mm below the edge of the fixed blade and must not extend beyond its edge. Then tighten the screws while holding the tool in place.
Maintenance and replacement of the clipper blades
After each use, brush hair off the blades with the cleaning brush, put a few drops of oil on the blades and wipe off excess oil with a dry cloth. For proper operation, the blades must be cleaned and oiled regularly, but the blade, handle and adapter must not be rinsed under water. To replace the blade unit, switch off the trimmer, unplug it from the mains and loosen the blade unit fixing screws with a screwdriver.
Included in the box
- BaByliss PRO FX7870GE trimmer with T-blade
- CA80M power adapter
- Cleaning brush
- Lubricating oil
- Zero gap setting tool
- Blade guards
- Screwdriver




Reviews
There are no reviews yet.