Description
Kettle with a stainless steel body
The element of this stainless steel kettle is concealed under the base of the jug, and the jug sits on a 360° swivel base. It switches off automatically once the water reaches boiling point. If it is switched on without water, the overheat cut-out trips: let it cool, fill it with water and it will work again after about 15 minutes.
Use
Before first use, remove all packaging and stickers, wind the cord under the base to the length you need and press it into the notch. Discard the water from the first two or three boils and rinse the jug and the filter separately. Fill the jug through the spout or the open lid to between the minimum and maximum marks, but never while it is on the base. Then place the jug on the base, plug it in and press the switch on the handle.
Limescale filter and cleaning
The removable limescale filter is a mesh that holds back scale particles so they do not end up in your cup; it does not change the hardness of the water. With very hard water the filter can clog within 10–15 uses, so rinse it under the tap when wet and brush it gently when dry. Clean the body with a damp sponge after unplugging and letting it cool, without scouring pads.
Descale at least once a month, more often with very hard water. Pour 0.5 l of white vinegar into the jug and leave it for an hour without heating, or boil 0.5 l of water, add 25 g of citric acid and wait 15 minutes. Then empty the jug and rinse it 5–6 times; descale the filter by soaking it in vinegar or diluted citric acid.
In the box
- kettle
- base
- limescale filter







Reviews
There are no reviews yet.