Description
Activated carbon filter for the SafetyPro AP2 purifier, capturing gases
As the third stage of the xTool SafetyPro AP2 air purifier, the xTool P5010397 activated carbon filter captures gases, vapours and odours released when materials are processed. Its activated carbon layer binds formaldehyde, volatile organic compounds (VOCs), carbon monoxide (CO) and sulphur dioxide (SO₂).

Key features
- Gas capture efficiency up to 88.5%.
- Service life of up to 600 operating hours.
- Sits after the pre-filter and the medium-efficiency filter in the purifier.
- When the filter reaches the end of its life, the xTool software shows a replacement prompt.
- Weight 2.3 kg.
Replacing the filter
Open the purifier door by its handle and take the filters out one by one; the cyclone above filter 1 stays in place. Remove the protective film from the new filter. Put filter 5 back first so that the alignment line is visible, then the other filters in sequence, each pushed all the way in. Close the door with the handle at the upper right.


Reviews
There are no reviews yet.