Description
Top-handle cordless chainsaw for cutting branches and tree care
The Makita DUC406ZB is a brushless cordless chainsaw with a 40 cm guide bar that runs on two Makita 18 V LXT batteries with a rated voltage of 36 V, and is sold without battery and charger. The saw chain runs at up to 20 m/s and the cutting length of the bar is 38.7 cm.
Torque Boost mode for thick branches
For thick or hard branches you can switch on Torque Boost mode, which runs for up to 60 seconds at a time. Chain speed follows the pressure on the trigger, and the main power switch turns itself off when the trigger is not pulled for a while. Indicators on the saw show the remaining charge of both batteries, and the saw switches itself off in the event of overload, overheating or a flat battery.
Chain oiling, tensioning and work in the tree
The chain is oiled automatically from a 200 ml oil tank with an inspection window, and the oil pump feed can be set in three steps with the universal wrench. Chain tension is set with the chain adjusting screw after loosening the retaining nut: tighten until the lower side of the chain sits in the bar groove. When working in a tree you can hang the saw on a rope with the carabiner and use the spike bumper against the trunk as a lever.
Cleaning and care
Clear chips and sawdust from the bar groove each time you sharpen or replace the chain, and clean inside the sprocket cover too. If oil reaches the bar tip poorly, clean the oil discharge hole with a slotted screwdriver. Before storage, clean the saw, run it without load to lubricate the chain and bar, fit the bar cover and empty the oil tank.
In the box
- Cordless chainsaw DUC406ZB
- Guide bar
- Saw chain Oregon 91PX
- Guide bar cover
- Universal wrench








Reviews
There are no reviews yet.