Description
Two-speed cordless chainsaw for felling and cross-cutting
This Power X-Change cordless chainsaw is designed for felling small trees and for cross and rip cuts in trunks, branches, wooden beams and boards. A switch selects one of two power levels: on ECO the chain runs at 6.0 m/s and on HIGH at 8.9 m/s. An LED shows the selected level, green for ECO and blue for HIGH.
Fitting the guide bar and chain
Undo the chain wheel cover fixing knob, take off the cover and lay the chain in the groove around the guide bar. Place the bar and chain on the saw, guide the chain around the chain wheel and refit the cover with the knob. Tension the chain with the tensioning knob until it can be lifted 3–4 mm in the middle of the bar, and only then tighten the fixing knob fully. While working, check the chain tension every 10 minutes, as the chain lengthens when it warms up.
Automatic chain lubrication and chain brake
The chain is oiled automatically from the 160 ml oil tank, whose level shows in a window with a min mark on the side of the housing. One fill lasts 15 minutes on average, depending on breaks and load. In a kickback the chain brake, triggered by the front hand guard, stops the chain in less than 0.1 seconds. When the switch is released, the motor brake stops the chain.
Cleaning and care
Clean the chain tensioning mechanism regularly with compressed air or a brush and keep the handles free of oil. The housing can be cleaned with a damp cloth and mild washing-up liquid when needed. If the saw will not be used for a longer period, empty the oil tank, dip the chain and bar briefly in an oil bath and wrap them in oil paper.
In the box
- Cordless chainsaw Einhell FORTEXXA 18/30
- Guide bar with adapter plate
- Saw chain
- Bar cover
- Operating instructions and safety instructions
Battery and charger are not included.




Reviews
There are no reviews yet.