Description
Robotic pool cleaner with a large battery and two-level filter
The cordless robotic pool cleaner WYBOT S2 runs on a battery and is made for pools up to 300 m² and up to 3 m deep. The 7800 mAh battery gives up to 210 minutes of runtime and charges fully in 3 hours.


Brush roller, pump and two filters
The pump with its brushless motor draws in the dirt and the brush roller guides it into the closed filter basket. The two-level filter consists of a 180 µm filter basket and a 40 ppi foam filter that also holds fine particles. The pump flow rate is 14 m³/h.



Infrared sensors and movement patterns
Infrared sensors detect obstacles and the robot plans its cleaning route itself. It cleans the floor in a star, cross or S pattern and the walls in an H, N or Z pattern. The robot climbs walls and handles steps, drains and shallow areas.

Modes by the button on the robot or in the app
You choose the mode directly with the mode button on the robot or in the WYBOT app, which connects over Bluetooth while the robot is out of the water. The app has seven modes: full pool, floor only, walls only, waterline, walls then floor, eco floor cleaning and turbo floor cleaning. Spot cleaning sends the robot to a particular area and the cycle timer sets up repeated cleaning; firmware updates over the app.


Pools and water
The S2 works in rectangular, oval and irregular in-ground pools with PVC, gunite, tile or other surfaces. Water temperature can be 5–35 °C, pH 7.0–7.8, chlorine up to 4 mg/l and salinity up to 5000 ppm.


Use
Charge the robot fully before first use at least 3 m from the pool edge. Press the power button and within 3 minutes lower the robot vertically into the water by its handle so that it sinks and the air escapes. After about 20 seconds of calibration the robot starts cleaning and parks itself by the wall when it finishes. Attach the included hook to a pool pole and lift the robot out vertically.
Cleaning and care
Switch the robot off, press the filter cover handle and lift the cover. Take out the filter basket and foam filter, empty them and rinse with clean water after every use. The foam filter is meant for floor cleaning; leave it out when the water is very dusty. Out of season, dry the robot, charge the battery fully, store the robot in a cool, ventilated place at 5–45 °C and charge the battery at least every 3 months.
In the box
- Robotic pool cleaner WYBOT S2, 1 pc
- Filter, 2 pcs
- Charger, 1 pc
- Hook for a pool pole, 1 pc
- Floats
- User manual
- Quick start guide



Reviews
There are no reviews yet.