Description
True RMS clamp meter for AC current up to 600 A
With its jaws the UNI-T UT216A clamp meter measures AC current up to 600 A without breaking the circuit: the conductor fits into the 30 mm jaw opening. AC current is measured at 50/60 Hz with an accuracy of ±(2.5% + 5).

Voltage, resistance and capacitance with test leads
The meter measures AC voltage up to 750 V over 40–400 Hz with an accuracy of ±(1.2% + 5) and DC voltage up to 1000 V with an accuracy of ±(0.8% + 3). Resistance reaches 60 MΩ and capacitance 60 mF. The meter selects the range automatically, and True RMS measurement shows the actual RMS value of AC signals. A diode test with a test voltage of about 3.0 V and an audible continuity test are also included.

Backlit display, NCV and torch
The backlit display measures 38 × 24 mm and reads up to 6000 counts. Non-contact voltage detection (NCV) shows whether voltage is present without touching the wire. Data Hold keeps the reading on the display, MAX/MIN shows the highest and lowest value, and relative mode shows the difference from a reference value. A torch is built into the housing.
Power and safety
The meter runs on three 1.5 V AAA batteries (R03), and auto power-off saves the batteries. A low-battery indicator appears at 3.6 V and below. Measurement category CAT III 600 V and CAT II 1000 V, DC voltage input impedance of at least 10 MΩ, and the input is protected against overload.
In the box
- Clamp meter UNI-T UT216A, 1 pc
- Test leads, 1 pair
- 3 AAA batteries (R03)
- Carrying pouch
- User manual in English



Reviews
There are no reviews yet.