Description
Hose timer with flow meter for tracking water usage
The tap-mounted RainPoint ITV117 hose timer with flow meter waters one zone on a set schedule and counts water used up to 9999 litres.

Current, last and total water usage on screen
The flow meter shows three readings: current usage, usage of the last watering and total usage. You can also set an upper limit on water usage.

Setting the schedule with the selector dial
The selector dial takes you through the steps clock, start time, watering duration and frequency. Duration can be set from 1 minute to 3 hours 59 minutes, and frequency to every 12 hours or every 1–7 days. In the ON position the timer waters automatically on the set schedule; in the OFF position watering is paused and the settings are kept.

Rain delay and manual watering
Rain delay postpones watering by 24, 48 or 72 hours and the saved schedule is kept. Manual watering can be started for 1 minute up to 7 hours 59 minutes without interrupting the schedule. When the battery runs low, the timer closes the valve automatically to prevent leaks.

Installation
The timer inlet fits a 3/4″ or 1″ BSP tap and the outlet a 3/4″ garden hose. The timer works at 0.5–8 bar water pressure and passes up to 35 l/min. It runs on two 1.5 V AA alkaline batteries.
- Turn off the garden tap and wrap PTFE tape around the tap thread.
- Screw the timer onto the tap by hand so the display is as upright as possible.
- Wrap PTFE tape around the outlet thread and screw on the hose.
- Before first use, activate the valve: tap closed, dial to ON, start manual watering and after the click turn the dial to OFF; repeat 3–5 times.
- Open the tap after setting the schedule.

Cleaning and care
Turn off the tap, remove the timer and check the inlet mesh filter. Rinse a dirty filter under running water. If the timer’s water channel is blocked, open the valve with manual watering and clean the channel with a small cleaning brush.






Reviews
There are no reviews yet.