Description
Aquarium gravel cleaner with telescopic tube and pump
The electric aquarium gravel cleaner uses a pump to draw water from the bottom together with the sediment that has collected between fish waste, food remains and gravel or sand grains. For aquariums of different heights, the telescopic tube lets you adjust the working height between 650 and 1050 mm. The cleaner starts with one button, and the flow rate can be changed with a flow regulator.

Filtering, water change and sand rinsing
When filtering, water passes through the filter sponge back into the aquarium and the dirt stays in the filter, so the bottom can be cleaned without draining the water. During a water change, a hose is connected to the outlet and the dirty water is led out of the aquarium.

To rinse sand, a sand rinsing cover is placed on the pump inlet; for a deep sand layer, an extended cover is included in the set. Fish waste and larger debris are removed by the duck-bill shaped suction nozzle.

Installation and use
To clean gravel, screw one end of the extension tube onto the thread of the pump outlet and the other end into the inlet of the three-way connector. For filtering, push the filter connection into the three-way connector and screw the outlet nut tight; to direct the water out, connect a hose to the outlet. To change the working height, loosen the telescopic tube fixing screw, set the length and tighten the screw again. In an aquarium with a low water level, dip the cleaner into the water at an angle; if the water reaches above the pump, press the power button to release the air and then fully submerge the cleaner.
Cleaning and maintenance
If the rotor becomes blocked, unplug the mains plug from the socket, take the pump apart, unscrew the screw on the front of the rotor, remove the rotor cover and clean the rotor. After cleaning the aquarium, tilt the cleaner to let out any water left inside, take the parts apart and dry them. If the filter sponge is so dirty that it blocks the water flow, replace it. For longer storage, keep the cleaner in a dry place.

Included in the set
- Handle
- Flow regulator
- Three-way connector
- Extension tube connector
- Pump with rotor and rotor cover
- Sand rinsing cover
- Extended cover
- Duck-bill shaped suction nozzle
- Outlet tube
- Filter
- Screw
- Angle connector
- Outlet nut and outlet opening


Reviews
There are no reviews yet.