Description
Reduce cooking odours in the kitchen with the built-in cooker hood Elica Elite 26 IX/A/60
Elica Elite 26 IX/A/60 is a 60 cm wide built-in telescopic cooker hood that is installed in the upper kitchen cabinet and stays almost unnoticeable when not in use. The pull-out front panel opens a large air intake, which helps remove cooking odours and steam from both smaller and medium-sized kitchens. The stainless steel finish, LED lighting and air flow of up to 581 m³/h make a practical solution for everyday cooking.
Main features
- Built-in telescopic design – the 60 cm wide cooker hood fits a standard kitchen cabinet, and the pull-out front panel increases the air intake only when you actually need it.
- Efficient air flow – an air flow range of about 240 to 581 m³/h lets you choose a suitable power for everyday cooking and intensive frying.
- Outlet to a Ø150 mm duct – the body of the unit is designed for connection to a 150 mm ventilation duct, and the built-in butterfly valve helps reduce backflow through the ventilation.
- LED lighting – the built-in LED lamps illuminate the hob evenly while using little energy.
- Electronic control – the buttons on the front panel let you choose between several speeds and also use a boost mode for a short time when there is more steam in the kitchen.
- Energy-saving operation – annual energy consumption is about 61 kWh and the unit belongs to energy class C, which is suitable for everyday home use.
- Readiness for recirculation mode – the model can be used with the carbon filter CFC0140343, so if needed the air can be returned to the room through the carbon filter when the ventilation duct cannot be used.
Compatibility and uses
The width of the cooker hood body is about 59.8 cm and the depth about 28 cm, which means the unit fits a standard 60 cm wide upper kitchen cabinet. This makes the model a good choice above most common electric and induction hobs and helps keep the overall look of the kitchen uniform and clean.
By factory setting, the Elica Elite 26 IX/A/60 is intended to work in extraction mode, where the air is led out through the ventilation duct. If there is no ventilation connection, the unit can also be used in recirculation mode with the carbon filter CFC0140343 offered as an accessory, which helps reduce odours before the air is returned to the room.
The installation height depends on the type of hob. In general, it is recommended to keep a distance of at least about 50 cm between the hob and the lower edge of the cooker hood for an electric or induction hob, and at least about 65 cm for a gas hob. Such a height ensures better extraction and helps meet safety requirements.
Installation and everyday use
Correct installation ensures efficient and quiet operation of the cooker hood. It is advisable to have the unit installed by a specialist who can take into account the specifics of the ventilation, electrical connections and kitchen furniture. During installation, the body is fixed inside the upper cabinet, the Ø150 mm duct is connected to the ventilation system and the height is adjusted according to the type of hob.
- To use it, pull the front panel out of the cabinet so that the air intake of the cooker hood opens fully and the LED lighting switches on.
- Choose a suitable speed with the electronically controlled buttons: a quieter mode is suitable for everyday cooking, and a stronger speed or boost mode for short-term frying.
- Let the cooker hood run for a few minutes after cooking has finished to remove the remaining steam and odours, and then push the front panel back into the cabinet.
Maintenance and cleaning
Regular maintenance helps preserve the efficiency of the unit and extends its life. Inside the cooker hood there is a metal grease filter that catches grease in the air. For easier cleaning, the filter should be removed at certain intervals and washed with warm water and a mild detergent. Some manufacturer instructions allow aluminium filters to be washed in a dishwasher too, but it is always worth checking the user manual first.
If you use the unit in recirculation mode with the carbon filter CFC0140343, the carbon filter must be replaced periodically, because its ability to bind odours decreases over time. The replacement interval depends on how often it is used and is stated in the manufacturer’s manual. Stainless steel surfaces should be cleaned with a soft cloth and a non-abrasive cleaning product to avoid scratches.
When to choose the Elica Elite 26 IX/A/60?
If you are looking for a discreet built-in cooker hood that fits a 60 cm kitchen cabinet, offers decent air flow and LED lighting, and can be used in both extraction and recirculation mode, then the Elica Elite 26 IX/A/60 is a balanced choice. The telescopic front panel keeps the line of the kitchen clean, stainless steel suits many interior design styles, and with several speeds and a boost mode the cooker hood can be set according to the specific cooking situation.




Reviews
There are no reviews yet.