Description
Inset granite sink BLANCO PLEON 6
The inset granite sink BLANCO PLEON 6 sits in the worktop cut-out with its low rim resting on the worktop. The colour is black, the outer size is 615 × 510 mm and the height 232 mm. The inner corners of the straight-lined bowl have a 15 mm radius. The tap position is on the rear ledge, which runs across the full width of the sink and flows smoothly into the rim. The bowl can be upgraded with the BLANCO Multi Match accessory set and cutting board, which add prep space over the sink.
Installation on the worktop
The cut-out is 595 × 490 mm with a tolerance of +2/−1 mm and a corner radius of 15 mm. An inset sink can be fitted into laminate, HPL, stone, glass, stainless steel or composite worktops. The tap hole is pre-milled from below: to open it, set a steel rod of at most 10 mm diameter on the centre of the mark, tap the rod lightly with a hammer, knock out the remaining pieces and file the hole to 35 mm. Open all the holes you need before final installation. Then apply silicone to the worktop round the cut-out, set the sink in the cut-out and fix it from below with the clamps, tightening their screws with a PZ2 screwdriver. Wipe off excess silicone straight away. The waste pipe connection is 331 mm below the worktop surface.
Bowl, drain and overflow
The bowl has a 3½-inch InFino basket strainer that is opened and closed by hand. The overflow is covered (C-overflow), with a slim cover over the overflow opening in the back wall of the bowl. The space-saving pipe of the waste and overflow kit routes the drain towards the back of the cabinet and leaves more room under the sink. BLANCO recommends a kit with a space-saving pipe when a pull-out waste sorter goes under the sink. The dishwasher drain hose connects to the separately sold trap.
SILGRANIT composition and properties
BLANCO’s composite material SILGRANIT PuraDur contains up to 80% quartz sand and is coloured all the way through. The rest is binder, minerals and pigments. The sink’s heat resistance is tested to EN 13310: a hot pot or a baking tray straight from the oven can go on the sink. BLANCO recommends placing an overheated pan on BLANCO TOP rails or a trivet. Metal marks from pots show more on light sinks, while white limescale shows more on a black sink. Coffee, tea and red wine only stain limescale, so removing the limescale removes the stain. SILGRANIT withstands food acids and vinegar- or citric-acid-based cleaners, so lemons and oranges can be cut directly on the sink. Chlorine-based and aggressive industrial cleaners can damage the surface.
Stone sink care and cleaning
For daily cleaning, use the soft side of a sponge and a little washing-up liquid. After washing, rinse the sink and dry it with a microfibre cloth so that no limescale, and with it no stains, build up. Once a week, remove limescale with BLANCO DailyClean+ (526305), citric acid or vinegar essence: apply it, leave it for 5 minutes, rinse thoroughly, clean with a sponge and dry. When weekly cleaning no longer removes stains, deep clean: first descale, close the drain, put laundry powder or gel in the bowl, fill it with water of at least 60 °C and leave it for at least two hours or overnight. Metal marks come off when rubbed in circles with a damp sponge and a little cooking oil. To clean the basket strainer, put a level teaspoon of dishwasher powder on the closed strainer, pour over about 250 ml of boiled water left to cool for a moment until it stops simmering, let it work, brush clean and rinse. Do not use steel wool, the scouring side of a sponge or corrosive, solvent-based or chlorine cleaners on the sink.
In the box
- Waste and overflow kit with space-saving pipe
- 3½″ InFino basket strainer
Needed separately
One trap is needed to connect the sink to the drain. The BLANCO 137267 kitchen sink trap connects the waste kit to a Ø40 or Ø50 mm drain pipe and has a dishwasher connection. With a waste sorter under the sink, the flat BLANCO 137287 trap fits instead, with a Ø50 mm outlet and connections for two appliances. A kitchen tap is bought separately too: BLANCO makes its SILGRANIT-look taps in the same colours as its SILGRANIT sinks, so the BLANCO LINUS-S, LINUS and MIDA-S taps in black match this sink.





Reviews
There are no reviews yet.