Description
Undermount stainless steel sink BLANCO ANDANO 340-U
The undermount stainless steel sink BLANCO ANDANO 340-U is fixed from below into the worktop cut-out, so the sink rim sits under the worktop. The surface has a satin polish, the outer size is 380 × 440 mm and the height 199 mm. The bowl base is flat and usable over its whole area, with rounded corners.
Undermount installation
The sink fits a dense, water-resistant worktop such as natural stone, composite or glass. Wood and wood-based boards are not suitable for this installation. The cut-out is 400 × 340 mm, tolerance +2/−1 mm, corner radius 22 mm.
Four fixing points are drilled into the underside of the worktop 27 mm from the cut-out edge: 5 mm in diameter and 13 mm deep. Before sealing, the rim is cleaned with isopropanol, then silicone is applied, the sink is pressed up against the worktop and fixed with the screws of the fixing kit, driven with a PZ 2 bit. After removing excess silicone, wait 24 hours before use.
The tap goes into the worktop: the 35 mm hole is drilled 60 mm from the cut-out edge. The waste outlet sits 290 mm below the top of the worktop. A dishwasher is connected via the separately sold trap.
Bowl, drain and overflow
The bowl has a 3½-inch InFino basket strainer that is opened and closed by hand. The back wall has a covered C-overflow, part of the InFino drain system. The waste pipe in the kit is space-saving: it runs towards the back of the cabinet and leaves more room under the sink, which is why BLANCO recommends it with a pull-out waste sorter.
Stainless steel and surface finish
The sink is made of 18/10 stainless steel, with 18% chromium and 10% nickel. With oxygen, chromium forms a thin invisible protective layer that renews itself. The first fine scratches on a new sink are normal and become less visible within a few days as the layer renews.
Satin polish is the finest surface of BLANCO stainless sinks, with a warm undertone. Hot pots and long sunshine do not change its shade. Reddish spots that appear on the surface are particles from other rusty objects or water pipes and wipe off.
Stainless sink care
For daily cleaning, put a little washing-up liquid on the soft side of a sponge and wipe in the brushing direction, as circular movements change the structure of a satin surface. Then rinse the sink and dry it with a microfibre cloth. To remove limescale, use vinegar essence diluted 1:10 with water, or a descaler.
Once a month, clean the sink thoroughly with a stainless steel cleaner: put a hazelnut-sized amount on a sponge and rub along the brushing direction. To clean the basket strainer, put a level teaspoon of dishwasher powder on the closed strainer, pour about 250 ml of boiling water over it, let it work, brush and rinse. Do not use abrasive cleaners, hypochlorite bleach, silver cleaning baths, the scouring side of a sponge, steel wool, products with chlorine or hydrochloric acid, or strong salt solutions left to act for long.
In the box
- Kitchen sink BLANCO ANDANO 340-U, 1 pc
- Waste and overflow kit with space-saving pipe
- 3½″ InFino basket strainer
- Fixing kit
Needed separately
To connect the sink to the drain you need one trap. The trap BLANCO 137267 connects the waste kit to a Ø40 or Ø50 mm drain pipe and has a dishwasher connection. With a waste sorter under the sink, the flat trap BLANCO 137287 fits, with a Ø50 mm outlet and two appliance connections. The kitchen tap is also bought separately, as is the drain connection for two single bowls fitted side by side.






Reviews
There are no reviews yet.