Description
Filter kitchen mixer tap BLANCO FONTAS II
The filter kitchen mixer tap BLANCO FONTAS II is a 3-in-1 tap with a brass body in a PVD steel finish. As a high-pressure tap it is meant for a kitchen where cold and hot water come under pressure from pipes in the wall. The spout is L-shaped and the lever sits on the right of the body.
Filtered water from its own handle
The right-hand lever mixes cold and hot mains water; turning the left-hand handle gives water that has passed through the water filter system. Filtered water has its own channel inside the tap and its own outlet at the end of the spout, so it stays apart from mains water. One hole in the sink or worktop is enough for all three kinds of water. The water filter system runs on cold water only, and the cold water at the filter inlet must be 4–30 °C.
Spout and flow rate
The spout reaches 205 mm and the tap is 300 mm high overall, leaving room to fill tall pots. The flow rate at 3 bar is 9 l/min. The aerator at the end of the spout mixes air into the water for a soft, even jet.
Installation and water pressure
The tap fits a 35 mm hole in the sink or worktop. The mounting surface may be up to 60 mm thick and the base of the tap is 45 mm in diameter. In a stainless steel sink, the supplied stabilising plate holds the tap firmly in place. There are three hoses under the tap: two connect to the hot and cold angle valves and the third to the G 3/8″ outlet of the water filter system.
The connection hoses are 500 mm long with a ⅜″ nut. BLANCO’s instructions show water pump pliers and a 19 mm spanner for the installation.
Before connecting the tap, flush the pipes: open the angle valves over a bucket and let hot and cold water run. After connecting, unscrew the aerators from the spout, open the lever and the filtered water handle and let the water run for at least 20 seconds. Then check that the connections are dry and screw the aerators back on.
The tap withstands up to 10 bar and hot water up to 70 °C; the water filter system works at 2–8 bar. An open boiler under the sink works without pressure and mains pressure could damage it, so such a boiler takes a low-pressure tap (ND) with three hoses for cold water, hot water and the boiler. Only a low-pressure tap can replace a low-pressure tap, because the number of hoses differs. BLANCO recommends having the tap installed by a specialist.
Finish and sink colour
BLANCO matches its PVD-finished taps to the sink material. The PVD steel tap matches BLANCO stainless steel sinks, especially those with a satin polish finish.
Tap care
After use, dry the tap with a soft cloth so that less limescale stays on the surface. Clean it with a soft cloth or the soft side of a sponge; the scouring side and cleaners containing chlorine damage the surface. Vinegar or citric acid solution removes limescale as long as it does not stay on the surface for long. If the tap starts to spray, limescale has built up in the aerator mesh: unscrew the aerator anticlockwise and leave it overnight in vinegar water or citric acid solution.
In a house with old water pipes, BLANCO recommends fitting a dirt filter between the angle valve and the tap hose, two in a row on a high-pressure system. According to BLANCO, spare parts are available for at least 10 years.
In the box
- Kitchen mixer tap BLANCO FONTAS II, 1 pc
- Flexible connection hoses, 500 mm, with ⅜″ nut
- Stabilising plate for installation in a stainless steel sink
Needed separately
Filtered water needs a BLANCO water filter system, which is installed under the sink and connected to the tap’s filtered water hose.




Reviews
There are no reviews yet.