Description
Fully modular power supply for an ATX 3.1 and PCIe 5.1 PC
The 1200 W fully modular Deepcool PN1200M power supply is 80 PLUS Gold certified and uses the ATX form factor. It is built to the Intel ATX 3.1 and PCIe 5.1 standards.
Cables for two CPU connectors and the graphics card
The graphics card is powered through a 16-pin graphics card connector and three PCIe 6+2-pin connectors. The motherboard has a 24-pin (20+4) connector and the CPU two 4+4-pin connectors. Each of the two drive cables carries four SATA connectors and one Molex connector. With detachable cables you connect only the cables you need.
Cooling, efficiency and protections
A 135 mm fan with a fluid dynamic bearing (FDB) cools the unit. 80 PLUS Gold certification means it runs at 90% efficiency or more at 50% load. Protection circuits cut the power on over-power (OPP), over-voltage (OVP), short circuit (SCP), over-temperature (OTP), over-current (OCP) and under-voltage (UVP), with surge and inrush protection (SIP) and no-load operation protection (NLO) in addition. During a mains interruption the unit holds its output voltage for at least 16 ms at 80% load.
Installation in the case
Before installing, make sure the mains cord is not connected, then fix the unit with the supplied screws following the case manual. The 4-pin part of the motherboard cable is detachable, so the cable also fits a 20-pin socket. Connect the CPU, SATA and PCIe cables, and connect a graphics card with a 16-pin socket preferably with the unit’s 16-pin cable. Finally connect the mains cord and turn the switch to the “I” position.
In the box
- Power supply Deepcool PN1200M, 1 pc
- Motherboard cable with 24-pin (20+4) connector, 1 pc
- CPU cable with 4+4-pin connector, 2 pcs
- Graphics card cables with three PCIe 6+2-pin connectors
- Graphics card cable with 16-pin connector, 1 pc
- Drive cable with four SATA and one Molex connector, 2 pcs
- Mounting screws
- Mains cord


Reviews
There are no reviews yet.