Description
Handheld oscilloscope, signal generator and component tester in one device
The handheld oscilloscope FNIRSI DSO-TC3 measures one channel with a 500 kHz bandwidth and a 10 MSa/s sampling rate and also includes a component tester and signal generator. The screen is a 2.4-inch TFT colour display with LED backlight and the housing measures 79 × 103 × 31 mm.

Oscilloscope mode with eight automatic measurements
Vertical sensitivity can be set from 10 mV to 10 V and the time base from 1 µs to 10 s; input coupling is AC or DC and input impedance 1 MΩ. With a 1X probe the range is ±40 V, with a 10X probe ±400 V. The AUTO key sets the waveform on screen automatically; trigger modes are auto, normal and single, on a rising or falling edge. The top of the screen shows eight parameters measured in real time: maximum, minimum, average, RMS and peak-to-peak voltage plus frequency, duty cycle and period. For probe compensation the device supplies a 1 kHz square wave.


Component tester identifies the pins itself
The tester identifies NPN and PNP transistors, N- and P-channel MOSFETs, IGBTs, JFETs, thyristors, triacs, diodes, dual diodes and Zener diodes, and measures resistance from 0.01 Ω to 50 MΩ, capacitance from 25 pF to 100 mF and inductance from 10 µH to 1000 mH. You can insert a component into the 1-2-3 socket in any order: the device assigns the pins automatically and for transistors also shows the gain hFE and the base-emitter voltage. The tester also measures battery voltage and polarity from 0.1 to 4.5 V.

Function generator with six waveforms
The generator outputs sine, square, triangle and ramp waves, pulses and DC voltage from the DDS socket. Sine, triangle and ramp waves run from 1 Hz to 10 kHz with 0–3.3 V amplitude; square waves and pulses run from 1 Hz to 100 kHz at 3.3 V. The duty cycle is freely adjustable from 0 to 100% for pulses and ramp waves.

Tools mode for sensors and infrared remotes
The tools menu offers a continuity test with buzzer, 0–40 V input voltage measurement and readings from a DS18B20 temperature sensor (0–85 °C) and a DHT11 temperature and humidity sensor (0–60 °C, 5–95%). The infrared decoder reads remotes using the NEC protocol and shows the user code, data code and signal waveform. The same menu holds automatic calibration and a PWM output.
Operation
On the home screen, choose one of four modes with the left and right keys and open it with OK. To test a component, lift the socket lever, insert the component, lock the lever and press OK. Connect the oscilloscope probe to the DSO MCX socket on the top edge and the ground clip to the ground of the circuit; the probe’s 1X/10X switch and the device setting must match.


Battery, charging and stand
The built-in 3.7 V, 1500 mAh lithium-polymer battery gives up to 4 hours per charge. A USB-C port (5 V, 1 A) on the bottom edge charges it; the indicator is red while charging and green when full. On the back is a folding stand that opens to 90°, keeping the device upright on the bench.



In the box
- Oscilloscope FNIRSI DSO-TC3, 1 pc
- Measuring probe
- 3 test clips
- USB-C cable
- User manual




Reviews
There are no reviews yet.