Description
Handheld oscilloscope and signal generator in one device
The FNIRSI DPOX180H is a two-channel handheld oscilloscope with 180 MHz (−3 dB) analogue bandwidth and a sampling rate of up to 500 MS/s on one channel or 250 MS/s on two. The same housing holds a built-in DDS signal generator.

Digital phosphor display that also shows rare events
Digital phosphor (DPO) technology shows how often the signal occurs at a point through brightness and colour, so jitter, noise and rare events stay visible on screen. The display refreshes up to 50,000 waveforms per second, which shortens the dead time between acquisitions and helps catch short disturbances in switching power supplies and digital buses.


Trigger, filter and signal analysis
Trigger modes are Auto, Normal and Single, on a rising or falling edge. A switchable 20 MHz hardware bandwidth limit reduces noise and higher harmonics. FFT shows the frequency spectrum and X-Y mode the amplitude and phase relation of the two channels, for example as Lissajous figures. Time base zoom is 2–1000× and a roll mode follows slow signals.


Signal generator and waveform chopping
The built-in DDS generator outputs 14 waveforms, including sine, square, triangle, sawtooth and pulse, up to 20 MHz, with frequency set in 1 Hz steps. The chopping function outputs a cut section of a measured waveform from the generator and stores up to 500 custom signals.


Storage and data export
The 120 Mbit internal memory holds up to 250 waveforms and 90 BMP screenshots. Data transfers to a computer over USB, which also updates the firmware.


Screen, battery and input protection
The 2.8-inch colour IPS screen has a resolution of 320 × 240 pixels. The AUTO button sets up a measurement in one press and cursors handle manual measurements. The input is protected against surges up to 400 V. The 3000 mAh lithium-ion battery lasts up to about 4 hours and charges at 5 V / 2 A, and auto power-off can be set from 5 minutes to 2 hours.




Reviews
There are no reviews yet.