Description
Roller shutter controller for blind position and slat angle
The roller shutter controller with energy metering Shelly Wave Shutter LR is a Z-Wave module with two relay outputs that opens, closes and sets a blind to any position. With a Venetian blind it also adjusts the slat angle.

Smart blind control in three operating modes
The controller has a shutter and Venetian blind mode and a manual travel time mode for motors without limit switches. Calibration is automatic or manual. The module has obstacle detection. It measures the connected motor’s consumption in watts and kilowatt-hours.
Z-Wave Long Range and Z-Wave Plus network
The module uses a Z-Wave 800 series chip and works at 868.4 MHz in a Z-Wave Plus network and at 864 MHz in a Long Range network. In a Z-Wave Plus network the indoor range is up to 40 m and the module also acts as a repeater. A Long Range link reaches up to 80 m indoors and up to 1000 m outdoors. With SmartStart the hub adds the device to the network once its code is scanned.
Communication is protected with Security 2 (S2) and AES-128 encryption. The firmware can be updated over the air (OTA).

Installation in a wall box
The module measures 37 × 42 × 16 mm and fits in the wall box behind the switch. Power is connected to the N and L terminals, so the controller needs a neutral wire. Supply voltage is 110–240 V AC and the operating temperature is –20 °C to 40 °C. It must be installed only by a qualified electrician with the circuit de-energised.


Switches and load
Inputs SW1 and SW2 accept momentary push-button switches or bistable switches that stay in position. Each relay output switches up to 10 A at up to 240 V AC. The controller has overheat protection at 80 °C as well as overcurrent and overvoltage protection.

In the box
- Roller shutter controller Shelly Wave Shutter LR, 1 pc
- User manual, 1 pc

Reviews
There are no reviews yet.