Description
Tripod TV stand with swivelling TV
This tripod TV stand is 1385 mm high and its legs span 873 × 420 mm. The TV rails fit a TV whose mounting holes are 100–600 mm apart horizontally and 100–400 mm vertically. The TV height on the column is set with a locking collar, recommended at 70–170 mm above the leg joint. The TV cable is held to a leg by two cable clips.
Safety rope and installation
To keep the TV from tipping over, the TV is attached to the wall with the included safety rope. You need a Phillips screwdriver, a spirit level and a drill with a 7 mm bit; the hex keys are included.
- Screw the three legs into the joint at the bottom of the column.
- Set the locking collar at the height you want and tighten it with a hex key before fitting the TV.
- Screw the cable clips to a leg.
- Fix the two rails to the back of the TV with suitable screws and plates, using washers and spacers if needed.
- With two people, lift the TV with its rails onto the column and route the cable into the clips; you can also lay the TV on a table or sofa and slide the column into the rails.
- Drill two holes of 7 mm diameter and 40 mm depth in the wall, fix the wall brackets with plugs and screws and connect the safety rope between the TV and the wall.
Check at least every three months that the stand is secure and safe to use.
In the box
- column with leg joint
- 3 legs
- 2 TV rails
- safety rope, 2 TV brackets and 2 wall brackets
- 2 cable clips with screws
- 4 wall screws and 4 wall plugs
- TV screws in five sizes (4 of each), 4 mounting plates, 8 washers and 8 spacers
- 2 hex keys












Reviews
There are no reviews yet.