Description
Monitor mount with a two-joint arm brings the screen away from the wall
The Lindy 40713 monitor wall mount carries one 10-26″ screen weighing up to 20 kg, attached with VESA 75 × 75 or 100 × 100 mm holes. The two-joint arm sets the screen 5.2–30.1 cm from the wall and pivots up to 180° at its joints.
The monitor arm tilts and hides the cable
Screen tilt is adjustable from −15° to +10°. The screen cable runs in the cable channel built into the arm and stays under its cover.
Wall installation
First remove the VESA plate from the arm with the wrench. Mark the holes using the wall plate, drill 50 mm deep holes with a 10 mm bit and fix the plate with the wall plugs and three wall bolts. Then fit the covers on the wall plate and screw the VESA plate to the back of the screen, using the rubber spacers for a screen with a curved back. Finally hang the screen with its plate on the arm, tighten the joint with the wrench and close the cable under the arm cover.
In the box
- Lindy 40713 monitor mount, 1 pc
- wall plate cover, 2 pcs
- Allen key, 1 pc
- wrench, 1 pc
- screws M4 × 12 and M4 × 20, 4 pcs each
- rubber spacer, 4 pcs
- wall bolt, wall plug and washer, 3 pcs each




Reviews
There are no reviews yet.