Description
Robotic lawn mower with cameras and RTK positioning
The mulching robotic lawn mower Airseekers Tron MAX cuts the clippings repeatedly in its FlowCut mulching chamber and leaves them on the lawn as mulch. The double-layer blade cuts the clippings finer so that they reach the soil.
Navigation and obstacle detection
The Tron MAX locates itself with a VIO camera, 3D vision and full-frequency RTK. The RTK base station receives BDS, GPS, GLONASS and Galileo satellite signals and sends correction data to the mower by LoRa radio over up to 120 m. The base station’s horizontal positioning accuracy is 0.8 cm + 1 ppm. Obstacles are detected with 3D vision and the bumper, and the robot also has a wide-angle camera front and rear.
Mowing on slopes with the large disc
The included large cutting disc gives a 27 cm cutting width, and the cutting height is adjustable from 3 to 9 cm. The drive wheels are powered by two direct-drive brushless hub motors, and the mower works on slopes of up to 46.6% (25°). When driving, the robot handles inclines of up to 65% (33°) and obstacles up to 60 mm high. The noise level in operation is 65 dB(A).
Battery and charging
The swappable 15 Ah lithium battery (21.9 V, 328.5 Wh) charges fully in the charging station in 150 minutes. The battery can be taken out of its compartment and replaced with a charged one. The rain sensor sits on the robot’s top panel.
Installation and mapping
The RTK base station goes in an open spot as close to the centre of the lawn as possible, at least 2 m from houses or walls and not under trees. The charging station is placed on a level surface with a clear area of 2 × 2 m in front and fixed with 6 stakes. To create the map, drive the Tron MAX along the lawn edge with the app’s remote control and keep it at least 10 cm from walls, fences and ditches.
Cleaning and care
Rated IPX6, the mower is protected against powerful water jets, so it can be rinsed with water. Before cleaning, switch off the battery and wipe the robot with a clean damp cloth. Do not use a pressure washer, alcohol or chemicals. With long use, replace the blade edge or the whole blade every 1–2 months.
In the box
- Airseekers Tron MAX robotic lawn mower
- Large cutting disc
- Charging tower, base plate and charging station adapter
- 10 base plate screws and 10 ground stakes
- RTK base station antenna, 2 support tubes, ground stake, adapter and cable
- 6 spare blades and 8 spare blade screws
- Mudguard and 3 mudguard screws
- Hex key and screwdriver (2-in-1) and special screwdriver
- User manual and quick guide













Reviews
There are no reviews yet.