Description
Robotic lawn mower with LiDAR navigation and edge trimmer
The LiDAR-navigated robotic lawn mower GOAT A3000 LiDAR PRO maps the garden with a rotating 360° LiDAR sensor that measures distances up to 60 m. A 3D ToF LiDAR and an AI wide-angle camera at the front detect obstacles, which the mower drives around. In the app you can set the cutting height, mowing direction and mowing speed separately for each area.
Edge trimming and schedule
After mowing an area, the GOAT drives along its boundaries, and the trimmer module on its side cuts the edges with trimmer line; you choose these edges in the app from the area and no-go zone boundaries. Trimming stops when the system detects a person nearby. The rain sensor stops work when it rains, and the mower resumes after a delay you can change in the settings.
In the ECOVACS HOME app you create a mowing schedule and an animal protection period, which by default keeps the mower idle from 19:00 to 7:00. Outside the map the GOAT locks and only the PIN code unlocks it.
Installation and mapping
The charging station tower clicks onto its base, and the station goes on a level, open area without slopes, within strong Wi-Fi coverage, where the grass around the station is below 6 cm. The power adapter must stay 30 cm above the ground, and you fix the station with the anchors and hex key only after setup. The trimmer module attaches to the mower with three screws and the brush clicks in beside it; then set a PIN code, pair the mower with the app over Bluetooth and 2.4 GHz Wi-Fi, and remove the LiDAR sensor cover. During mapping you steer the mower from the app from up to 6 m away, and along a clear lawn edge it follows the boundary by itself.
Cleaning and maintenance
Wipe the LiDAR sensor once a week and the AI camera and ToF sensor about every 1 to 2 weeks. Replace the blades about every 4 to 6 weeks, and the trimmer line and brush every 4 to 8 weeks. Clean the blade discs and wheels with a brush and the other parts with a clean dry cloth, and cover the LiDAR sensor before turning the mower over. For winter, charge the GOAT fully, switch it off, mark the station position and keep the mower in a cool, ventilated, dry place, charging it every 6 months.
In the box
- Ecovacs GOAT A3000 LiDAR PRO robotic lawn mower
- Trimmer module, trimmer brush and 2 screws
- Charging station tower and base
- Power supply
- Hex key and 8 base screws
- Spare parts: 18 blades with screws, trimmer brush and trimmer line spool
- Instruction manual and quick start guide












Reviews
There are no reviews yet.