Description
Smart water leak sensor kit monitors three leak points at once
Made up of three SWS51 sensors and an SBS50 base station, the smart water leak sensor kit X-Sense SWS54 connects through the base station to your Wi-Fi network and the X-Sense Home Security app. When water is detected, the sensor sounds a continuous alarm with a flashing red LED, the base station reports a warning and your phone gets an instant push notification. When the leak stops, the app sends an “Alarm Ended” message.

Probes on the front and underside of the sensor
Each sensor has two front probes for leaks and four on the underside for flooding; the alarm triggers at a water layer of about 0.4 mm. The base station repeats the sensor alarm with its own 100 dB sound signal.

Notifications and silencing the alarm in the app
In the X-Sense Home Security app you see the status of your devices, can silence the alarm and share access with other household members. The button on the sensor or base station also silences the alarm. The Remind Me Later function silences the alarm for 10 or 30 minutes, or 2, 6 or 12 hours, and if the leak continues, the sensor alarms again afterwards.

Base station and radio link across the house
The sensors talk to the base station on 868 MHz with a range of up to 500 m in open space, and one base station pairs up to 50 devices. The base station is powered by the supplied power adapter and works on a 2.4 GHz Wi-Fi network.

Installation and setup
Place the sensor flat on an even surface near water pipes, a dishwasher, washing machine, toilet or water heater. To set up, plug in the base station, add it in the app with its QR code and hold the pair button for 5 seconds until the LED flashes yellow. Then add the sensor in the app and hold the button on its underside until the LED flashes blue. Pressing the test button makes the sensor beep three times with a flashing LED.

Battery replacement and maintenance
The two replaceable AAA batteries last up to 3 years. When the battery runs low, the red LED flashes once every 60 seconds with a beep and the app sends a notification. To replace the batteries, undo the screws, insert two new AAA batteries, align the two halves of the housing by their positioning marks and refit the screws. After an alarm, shake the sensor a few times to clear water from the buzzer opening and wipe the top and bottom probes with a dry cloth and paper towel.
In the box
- Water leak sensor X-Sense SWS51, 3 pcs
- Base station X-Sense SBS50, 1 pc
- AAA batteries (fitted in the sensors)
- Power adapter
- Power cable
- User manual

Reviews
There are no reviews yet.