Description
Smart water leak sensor also detects condensate and distilled water
The smart water leak sensor Shelly Flood S Gen4 connects over Wi-Fi directly to your home network and the Shelly Smart Control app; in a Zigbee network it needs a Zigbee hub. Three large stainless-steel pads also respond to clean and low-conductivity water. When water appears, the sensor sends an instant phone alert and signals with its built-in buzzer and LED.

Use on the floor and IP67 protection
The sensor is ready to use out of the box as the battery is already fitted: before first use, remove the insulating and protective elements. Place it on a flat surface under a water heater, dishwasher, washing machine or sink, where the low 23 mm housing also fits into a narrow gap. The IP67 rating means the housing is dust-tight and withstands temporary immersion in water. The sensor checks for a change of state every 5 seconds.


Flood and rain modes with three alarm profiles
In flood mode the sensor triggers an alarm as soon as water is present; in rain mode it only reports the change of state outdoors, which automations can use to control a motorised awning or sprinklers. The Intense profile keeps the buzzer on for 10 minutes and then for 1 minute every 5 minutes, the default Normal profile for 5 minutes and then for 1 minute every 30 minutes. The Economic profile reports a leak by notification only and is meant for places you do not visit for a while, such as a holiday cottage. A single press of the button mutes the buzzer.

Matter, Zigbee and smart home platforms
The sensor ships with Matter firmware; five quick presses of the button switch it to Zigbee firmware and back. It works with Amazon Alexa, Google Home, Samsung SmartThings and Home Assistant and supports local automation actions, such as closing a compatible smart water valve on a leak. Indoor radio range is up to 30 m over Wi-Fi 6 and up to 100 m over Zigbee 3.0. The sensor can also share its state with a home automation system over MQTT and with up to 10 URL actions.


Replacing the battery
The supplied CR123A battery lasts about 2 years, depending on the battery, usage and network signal strength. When the battery level drops below 20%, the buzzer gives short beeps. To replace the battery, turn the cover anticlockwise, remove the empty battery, insert a new CR123A battery with the correct polarity and turn the cover clockwise. To keep the seal tight, seat the O-ring correctly and close the cover without excessive force.
In the box
- Water leak sensor Shelly Flood S Gen4, 1 pc
- CR123A battery, 1 pc (fitted)


Reviews
There are no reviews yet.