Description
Fuel injector cleaner and tester for servicing four petrol injectors
Ultrasonic cleaning and microcomputer-controlled fuel pressure are combined in the fuel injector cleaner and tester ANCEL ANJ400. It cleans and tests car GDI, EFI, MPI and SFI injectors, and you follow the main parameters in real time on the digital display.

Built-in ultrasonic bath cleans injector cavities
The integrated 100 W ultrasonic cleaner uses the cavitation of ultrasonic waves to remove stubborn carbon even from complex shapes, cavities and pores of the injector. You fill the bath with cleaning agent to about 20 mm above the injector needle valve, and when the time is up the unit stops and beeps.

The injector tester measures uniformity, leaks and volume
In the uniformity and spray test you compare the injectors’ delivery under the same condition and see each spray pattern with backlighting; the same test also finds the injector’s minimum opening pulse. The leak test checks needle valve sealing under system pressure and runs for 1 minute by default. The flow test measures 15 seconds of constant injection, and a deviation shows wear or clogging.

Three working modes and saved settings
The working modes test simulates acceleration, deceleration, and acceleration with deceleration. You can set the speed from 100 to 9,900 rpm in 10 rpm steps and the test time from 5 to 300 s in 5 s steps, and change fuel pressure during the test with the + and − keys. In the settings you can save display and backlight brightness and the buzzer level.

Low-resistance injectors and backflushing
A dedicated motherboard lets the unit run long tests on 1 Ω injectors, and the resistance test is accurate to 0.1 Ω. On top-feed injectors, backflushing drives test fluid from outlet to inlet and flushes dirt out of the injector and its filter. On a sudden power cut the unit reduces fuel circuit pressure automatically.

Operation
Before work, fill test fluid through the top-left port to about half the tank and check the level on the level indicator. Fit the injectors with a suitable connector and a lubricated O-ring and start the selected function with the RUN key. The maker recommends the order ultrasonic cleaning, uniformity test, leak test, flow test and working modes test. On-vehicle cleaning runs through the unit’s fuel hoses without removing the injectors.

Cleaning and care
After work, drain the test fluid into a fuel container, switch the unit off and unplug it. Suck the cleaning agent out of the ultrasonic bath and wipe the bath and the top of the unit with a soft dry cloth. To prevent evaporation, empty the tank of test fluid and store reusable fluid in a safe place.
In the box
- Fuel injector cleaner and tester ANCEL ANJ400, 1 pc
- Adjustment screw, 2 pcs
- Fuel funnel, 1 pc
- Fuel hose, 1 pc
- Injector washer Ø 11, 4 pcs
- Flat injector plate Ø 14, 4 pcs
- Pulse cable for four injectors, 1 pc
- Power cable, 1 pc
- Special cable, 4 pcs
- Upper fuel rail, 1 pc
- Connector sealing ring 7.52 × 3.53, 10 pcs
- R1/4 plug, 3 pcs
- European standard connector Ø 13.6, 4 pcs
- Standard connector Ø 10.6, 4 pcs
- Mercedes-Benz mechanical injector connector M12 × 1.5, 4 pcs
- GDI injector connector Ø 12.5, 4 pcs
- GDI injector connector Ø 9.8, 4 pcs
- GDI injector connector M18, 4 pcs
- Tool kit, 1 pc





Reviews
There are no reviews yet.