Description
Sink cabinet waste separation system BLANCO FLEXON II for drawer installation
The sink cabinet waste separation system BLANCO FLEXON II 60/2 is installed in the drawer of the base cabinet, so the buckets come out with the drawer when you open the cabinet. The large and the smaller bucket hang side by side in the frame, so waste can be sorted into two kinds. The total bucket volume is 49 litres.
The system cover runs on its own runners fixed to the cabinet side walls. The large, smooth surfaces are easy to clean.
Installation in the sink cabinet
The installation height above the drawer bottom is 355 mm, or 325 mm without the system cover. The installation depth, measured as the drawer inner size, is 400 mm. The drawing gives the cabinet inner width as 562 mm or 568 mm, depending on the wall thickness.
In a cabinet with frame and panel doors, the system fits when the door frame is at least 90 mm wide. A U-shaped support clicks onto the frame, and the frame is fixed centrally in the drawer: four screws into the drawer front panel and two into the drawer bottom.
The cover runners are fixed to the cabinet side walls at least 5 mm above the frame. The buckets are then hung in the frame and the cover slid onto the runners. The screws go in without pre-drilling and need a TX20 screwdriver.
In the box
- Waste separation system BLANCO FLEXON II 60/2, 1 pc
- Frame with U-shaped support for drawer installation
- System cover and 2 runners
- Bucket, 30 l
- Bucket, 19 l
- 12 fixing screws
Required separately
The frame is fixed into the cabinet’s own drawer, so the base cabinet needs a top and a pull-out drawer.





Reviews
There are no reviews yet.