Description
Camera flash with manual output and a radio receiver
The camera flash Godox TT520III with a single-contact hot-shoe foot is an on-camera flash with a guide number of 33 (ISO 100, metres). You set the output yourself in eight steps from 1/128 to 1/1, and each step can be fine-tuned in third-stop increments.

Wireless triggering by radio or light sensor
The built-in 433 MHz radio receiver works with the included RT transmitter on 16 channels up to about 15 m away, so you can place the flash away from the camera. In S1 mode the flash fires with the main flash; in S2 mode it skips the pre-flash and fires with the main burst. The flash can also be connected to the camera with a sync cord.
Swivelling head, reflector card and wide-angle panel
For bounce flash the head rotates horizontally 0–330° and tilts −7° to 120°. The pull-out wide-angle panel widens the lit area, and the reflector card adds a catchlight to the eyes.

Powered by four AA batteries
The flash runs on four AA NiMH rechargeables or LR6 alkaline batteries. With NiMH cells it gives about 400 full-power flashes with a recycle time of about 1.8 seconds. On the camera it enters standby after 30 minutes, in wireless or optical mode after 60 minutes.
Use
Slide the battery cover open in the direction of the arrow, insert four batteries the right way round and slide it shut. Slide the flash foot into the hot shoe and turn the locking ring clockwise until the flash is firmly locked. Switch the radio on by holding MODE for 2 seconds, then set the same channel on the RT transmitter and the flash.
Cleaning and care
Clean the flash with a dry soft cloth. For longer breaks take the batteries out so a leak cannot damage the flash.
In the box
- Camera flash Godox TT520III, 1 pc
- RT transmitter, 1 pc
- Mini stand, 1 pc
- Storage pouch, 1 pc
- Instruction manual, 1 pc






Reviews
There are no reviews yet.