Description
Heat gun with station for electronics soldering
The FNIRSI SAG-55 PLUS heat gun with display runs on mains power at 550 W; you can set the temperature from 100-450 °C and the air flow up to 80 l/min. The set is designed for precision electronics work and SMD servicing, such as phone and motherboard repair and bending plastic tubing.


PID control stabilises the temperature
Digital PID control (a regulator that measures the temperature and adjusts the heating power continuously) monitors the temperature in real time and holds the set value without spikes. This reduces the risk of damaging components while soldering.

Air flow in 20 steps and cold air mode
The brushless fan’s air flow adjusts linearly in 20 steps: a gentler stream for delicate SMD components, a stronger one for larger parts. One press of a button switches on cold air mode, which cools components quickly after soldering.


The heat gun sleeps in its station
When you place the heat gun in the station, a magnetic position sensor puts it into sleep mode automatically. Cooling then starts and draws heat away from the heater faster, with no need to switch the device off by hand.

Colour display and three presets
The 1.54-inch colour LCD display on the handle (240 × 240 pixels) shows the temperature, air flow level, operating mode and selected preset. You switch with one press between temperature and air flow combinations stored in three presets.

Automatic heating cut-off on a fault
Built-in sensors monitor the device continuously and, on a fault, the heating switches off automatically.

Hot air gun nozzles and nozzle holder
The heater is 80 mm long with a 21.6 mm diameter and takes standard 850 series nozzles. The station base has a nozzle holder, the housing is metal and heat-resistant silicone, and the handle cable and the power cord are each 1.2 m long.

In the box
- FNIRSI SAG-55 PLUS heat gun, 1 pc
- Heat gun station
- Power supply
- Power cord
- 6 mm nozzle set
- User manual



Reviews
There are no reviews yet.