Description
Undermount stainless steel sink BLANCO SOLIS 450-U
The undermount stainless steel sink BLANCO SOLIS 450-U is fixed from below into the worktop cut-out, so the rim of the sink sits under the worktop. The surface is brushed, the outer size is 490 × 440 mm and the height 194 mm. The bowl corners have a radius of 42 mm.
Installation under the worktop
The sink suits only a dense, continuous worktop such as natural stone, glass or composite. The worktop cut-out is 450 × 400 mm with a tolerance of +2/−1 mm and a corner radius of 42 mm. The tap is fitted in the worktop: the hole is 35 mm in diameter and is drilled 60 mm from the back edge of the cut-out.
For the fixing points, holes 5 mm in diameter and 13 mm deep are drilled into the underside of the worktop. Before fitting, the rim of the sink and the worktop are cleaned with isopropanol, the rim is sealed with silicone and the sink is pressed up against the worktop from below. The fixing screws are tightened with a PZ 2 screwdriver and excess silicone is wiped off. After sealing, wait 24 hours before using the sink.
Bowl, drain and overflow
The bowl drain has a 3½″ InFino basket strainer, opened and closed by hand, and the overflow is the covered C-overflow. The supplied waste and overflow set runs the pipe towards the back of the cabinet, leaving more room under the sink. BLANCO recommends the set with the space-saving pipe when a pull-out waste sorting system goes into the sink cabinet. A dishwasher connects to the separately sold trap.
Stainless steel and surface finish
The sink is made of 18/10 stainless steel, containing 18% chromium and 10% nickel. Together with oxygen, chromium forms a thin, invisible protective layer on the surface that renews itself. Fine scratches on a new sink are normal, and many become less visible within a few days as the layer renews.
The surface has a brushed finish. Its colour stays the same when a hot pot is placed on the sink or when the sun shines on it for a long time. Reddish spots on the surface are rust carried over from other rusty objects or the water pipes, and they wipe off.
Stainless steel sink care
For daily cleaning put a little washing-up liquid on the soft side of a sponge and clean along the brushing direction, as circular movements can permanently change the surface structure. Then rinse the sink and dry it with a microfibre cloth to leave fewer small spots. To remove limescale, mix one part vinegar essence with ten parts water or use a descaler.
Once a month clean the sink thoroughly with a stainless steel cleaner: put a hazelnut-sized amount on a sponge and polish along the brushing direction. To clean the basket strainer, put a level teaspoon of dishwasher powder on the closed strainer, pour over about 250 ml of boiling water, leave it to work, brush and rinse.
The surface needs gentle products: keep abrasive cleaners, cleaners containing chlorine or hydrochloric acid, hypochlorite bleach, silver cleaning baths, long-acting strong salt solutions, stiff brushes, the scouring side of a sponge and steel wool away from it.
In the box
- Kitchen sink BLANCO SOLIS 450-U, 1 pc
- Waste and overflow set with space-saving pipe
- 3½″ InFino basket strainer
- Fixing kit
Needed separately
To connect the sink to the drain you need one trap. The BLANCO 137267 kitchen sink trap connects the waste set to a Ø40 or Ø50 mm drain pipe and has a dishwasher connection. With a waste sorting system in the sink cabinet, the flat BLANCO 137287 kitchen sink trap fits, with a Ø50 mm outlet and two appliance connections. The kitchen tap is also bought separately.






Reviews
There are no reviews yet.