Description
Automatic heat press for DTF transfers with up to 100 kg of pressure
The automatic heat press xTool WonderPress V1.0 lowers the plate by itself and lifts it automatically after pressing. Thick items such as sweatshirts fit under the plate. The xTool 3D Form and Craft Oven modules, sold separately, work with the same main unit.

Pressure, temperature and time set with the control knob
Turning the knob slowly changes the value by 1 unit, turning it fast by 5 units. From the material presets you pick a material and the press sets the temperature, time and pressure. The heating tubes are twice as densely spaced so that heat spreads evenly across the plate. Over Wi-Fi and Bluetooth the press connects to the xTool app, where you can use the maker’s recommended settings and monitor the device status.


Use in automatic and manual mode
Before first use, remove the protective foam, pull out the base, flip the press module and put it back on the base. Pre-press the garment to flatten and dry it, then place the DTF film and the heat-resistant sheet on top. In manual mode you push in the base and press Start/Stop; in automatic mode pressing starts when the base is pushed in. After 15 minutes of inactivity the device switches off and saves the last settings.

In the box
- Heat press xTool WonderPress V1.0, 1 pc
- Press module with replaceable heat insulation pad, 1 pc
- Heat-resistant sheet, 1 pc
- Quick start guide and safety instructions

Reviews
There are no reviews yet.