Description
Automatic heat press with three modules for garments and mugs
The automatic heat press xTool WonderPress V1.0 All in One is built around one main unit and comes with the xTool Craft Oven and xTool 3D Form modules. The modules change without tools and the unit recognises the fitted module; the screen shows that module’s settings.

Press module for thicker garments
A sweatshirt fits under the plate and pressure is set in 1 kg steps, temperature in 1 °C steps. The heating tubes are twice as densely spaced so that heat spreads evenly across the plate. In automatic mode pressing starts when the base is pushed in, and the plate lifts by itself afterwards.

Heat chamber for DTF film, mugs and polymer clay
With the Craft Oven module you can cure DTF powder directly on the film; curing one film of up to 432 × 432 mm takes about 3 minutes. The 398 × 158 × 80 mm chamber holds 3 mugs at a time for shrink-wrap sublimation and also bakes polymer clay and bends acrylic. A three-layer filter (H11 filter, carbon layer and H13 HEPA filter) captures up to 99.95% of the fumes from curing.


Vacuum forming and printing on curved surfaces
The built-in vacuum pump of the 3D Form module pulls the film around a curved item so that the design covers the edges too: the 3D sublimation area is up to 122 × 229 mm, for example on a phone case, badge or keycap. For vacuum forming the module softens a plastic sheet and pulls it around the template with up to 90 kPa of vacuum; the forming area is 250 × 195 mm and the forming height up to 90 mm. An infrared sensor monitors the sheet temperature and shows when to start forming.

Operation with the control knob and the xTool Studio app
Parameters are selected on the 45.7 mm screen with the control knob; 35 built-in settings also work offline. Over Wi-Fi and Bluetooth the xTool Studio app opens a cloud library of settings. Before first use, remove the protective foam and flip the press module in the base. Pre-press the garment, place the DTF film and the heat-resistant sheet on top and, in manual mode, start pressing with the Start/Stop button. After 15 minutes of inactivity the unit switches off.


In the box
- Heat press xTool WonderPress V1.0, 1 pc
- Press module with replaceable heat insulation pad, 1 pc
- xTool Craft Oven module, 1 pc
- xTool 3D Form module, 1 pc
- Heat-resistant sheet, 1 pc
- Quick start guide and safety instructions





Reviews
There are no reviews yet.