Description
Filament dryer for one spool of PLA, PETG and TPU
The Sunlu FilaDryer S1 Plus is a single-spool filament dryer that holds one spool up to 210 mm in diameter and 85 mm wide. It takes 1.75 mm, 2.85 mm and 3.00 mm filament, such as PLA, PETG, ABS and TPU.


Temperature, timer and humidity reading with two buttons
With the left and right buttons you set the temperature from 35 to 55 °C, a long press on the left button sets the drying time from 1 to 99 hours, and a long press on the right button shows the chamber’s relative humidity. The maker recommends drying PLA and wood filament at 45–50 °C and PETG and TPU at 50–55 °C for 4–6 hours.


Use
Place the spool in the chamber and run the filament through outlet 1 or 2, depending on where your printer’s inlet is, so the filament dries while you print. Connect the power adapter and switch the dryer on with the left or right button; pressing both buttons together switches it off.

In the box
- Filament dryer Sunlu FilaDryer S1 Plus, 1 pc
- Power adapter, 1 pc
- PTFE tube, 1 pc
- User guide, 1 pc


Reviews
There are no reviews yet.