Description
Filament dryer with annealing mode for engineering filaments
The Sunlu FilaDryer E2 filament dryer removes moisture from filament and anneals printed parts at up to 110 °C. A 500 W PTC heater brings the chamber to 50 °C in about 20 minutes and to 70 °C in about 30 minutes. The chamber holds two 1 kg spools, one 2 kg spool or one 3 kg spool up to 250 mm in diameter and 153 mm wide.


Annealing mode for stronger parts
In MO2 mode the dryer heat-treats printed parts on the supplied annealing tray. Annealing reduces internal stresses from printing and improves the part’s mechanical properties. Choose the annealing temperature and time according to the filament maker’s recommendations.

Temperature, timer and humidity reading on the touchscreen
On the touchscreen you choose the filament type and working mode and set the temperature from 35 to 110 °C and the time from 0 to 99 hours. The screen shows the actual and set chamber temperature, relative humidity from 10 to 90% and the elapsed time. An LED strip on the front shows the dryer’s status.


Sealed and insulated filament dryer housing
A magnetic lid and silicone seals keep outside moisture out of the chamber. Double thermal insulation keeps the chamber temperature stable even above 100 °C.



Use
The dryer takes 1.75 mm, 2.85 mm and 3.0 mm filament, including PLA, PETG, TPU, ABS, ASA, PC, PVA and carbon or glass fibre PA. Fit the roller into the bearings and the groove at the bottom of the chamber, place the spool on the roller and push the PTFE tube into the filament hole so that 2–3 cm of tube is inside the chamber. Thread the filament through the tube and close the lid. Keep the silicone plug of the filament hole open while drying so moisture can escape, and close it afterwards.

In the box
- Filament dryer Sunlu FilaDryer E2, 1 pc
- Annealing tray, 1 pc
- Power cable, 1 pc
- PTFE tube 1 m, 2 pcs
- User manual, 1 pc




Reviews
There are no reviews yet.