Description
Filament dryer lid for the first-generation Bambu Lab AMS
The Sunlu AMS Heater is a filament dryer for the Bambu Lab AMS that fits in place of the original lid of the AMS (1st generation). The AMS keeps its sealed storage and multi-colour printing, and the filament dries while you print.



Even heating with a metal roller fan
A PTC heater brings the AMS to 70 °C in about 20 minutes and a metal roller fan guides warm air around the spools. Two thermal protection switches cut the heating if it overheats. The maker recommends drying PLA, PETG and TPU at 50–55 °C for 4–6 hours, ABS, ASA and PVA at 65–70 °C for 4–6 hours, and PA and PC at 65–70 °C for 10–12 hours.


Automatic humidity control
Drying starts when humidity in the AMS rises to the set value between 25 and 50% (50% by default) and stops at 20%, so the spools stay dry for printing. The display shows temperature, humidity from 10 to 90% and a working time of up to 99 hours.

Installation and use
Empty the AMS, undo the four hinge screws of the lid and remove the lid. Swap the hinges for the supplied ones, fit them on the dryer’s pins, place the dryer on the AMS base and tighten the four screws. The spool goes into its slot and the filament is pushed about 2 cm into the feeder, after which the AMS feeds it on by itself. While drying, slide the vent cover to the open position.

In the box
- Filament dryer Sunlu AMS Heater, 1 pc
- Hinge, 4 pcs
- Hex screw, 8 pcs
- Hex key, 1 pc
- Power cable, 1 pc
- User manual, 1 pc



Reviews
There are no reviews yet.