Description
Filament dryer for four spools and several printers
The Sunlu FilaDryer S4 is a filament dryer for four spools with a 450 × 210 × 211 mm chamber. A 330 W PTC heater brings the chamber to 50 °C in about 30 minutes, and the maximum temperature is 70 °C.

Eight outlets for multi-colour and multi-printer work
During drying the filament can run through eight outlets in PTFE tubes straight to the printers. The dryer takes 1.75 mm, 2.85 mm and 3.00 mm filament.


Three fans for even drying
Three fans on the sides and bottom circulate warm air through the whole chamber and hold the temperature within ±3 °C. The maker recommends drying PLA, PETG and TPU at 50–55 °C for 4–5 hours, ABS, ASA and PVA at 65–70 °C for 4–5 hours, and PA and PC at 65–70 °C for 7–9 hours.



Timer and humidity modes
In MO1 mode the dryer switches off when the timer of up to 99 hours ends. In MO2 mode it monitors humidity after the timer ends: when humidity rises to the set value of 30–50%, heating starts automatically and runs until humidity falls to about 25%. If humidity does not fall, check that the lid is closed or raise the temperature by 5 °C.

Use
Cut a piece of about 8 cm from the PTFE tube, open the lid and place the spool in the chamber. Thread the filament through the outlet and the tube, connect the power and press the switch. On the touchscreen you choose the filament type with its recommended temperature and set the temperature, drying time and °C or °F unit.
In the box
- Filament dryer Sunlu FilaDryer S4, 1 pc
- PTFE tube 100 cm, 2 pcs
- Power cord, 1 pc
- Roller, 8 pcs
- User guide, 1 pc






Reviews
There are no reviews yet.