Description
Ceiling-mount wireless access point with Wi-Fi 6
The ceiling-mounted Wi-Fi 6 wireless access point MikroTik cAP ax works on two bands with two chains each: data rates reach 1200 Mbit/s on 5 GHz and 574 Mbit/s on 2.4 GHz. The built-in antennas have a gain of 5.5 dBi. For secure connections it supports OWE, WPA3-PSK and WPA3-EAP authentication, and 802.11r for roaming.
RouterOS v7 and central management with CAPsMAN
Inside are a quad-core 1.8 GHz IPQ-6010 processor, 1 GB of RAM, 128 MB of NAND storage and pre-installed RouterOS v7 with a level 4 licence. In RouterOS you can set up firewall rules, IPsec hardware encryption, WireGuard, BGP and VPN tunnels. CAPsMAN central management configures many cAP ax access points from one place and can run on another MikroTik device, such as the main router. The mode button in the centre turns the LEDs off and can be reassigned to run a RouterOS script.
Power and PoE output
Power comes from the 802.3af/at PoE input on ETH1 or from the DC jack, both accepting 18–57 V. The passive PoE output on ETH2 can power another device, such as an IP camera, a network switch or another cAP ax. PoE output current is up to 600 mA with an input below 30 V and up to 400 mA with an input above 30 V. When the output current exceeds 300 mA, the access point must be powered via the DC jack. Maximum power consumption is 9 W without attachments and 28.2 W with the PoE output loaded.
Installation
The access point mounts on the ceiling with the supplied ceiling mount, mounting bracket and fastening set. Power can be supplied with the included PoE injector to ETH1 or with the 48 V power adapter to the DC jack.
In the box
- MikroTik cAP ax wireless access point
- 48 V 0.95 A power adapter
- gigabit PoE injector
- ceiling mount
- mounting bracket
- fastening set with wall plugs and screws




Reviews
There are no reviews yet.