Description
Air purifier for smoke and odours from laser engraving and 3D printing
The Creality Falcon AP1 air purifier connects to the engraver through its 65 mm inlet and an exhaust hose, and captures the smoke, odours, dust and gases produced by laser engraving and 3D printing. The filtered air can be released straight into the room. The maker states a suction pressure of up to 1700 Pa.

Two filters for dust and odours
The first filter is a HEPA composite filter with a built-in pre-filter layer: HEPA stands for a high-efficiency particulate filter, which according to the maker captures up to 99.97% of 0.3 µm particles. The second is an activated carbon filter whose 1.4 kg of carbon binds engraving odours and gases.



Air purifier for laser engravers works with the engraver
The fan button switches between three speeds and an automatic mode. Automatic mode is available when the purifier is connected to the engraver, and the purifier then starts and stops with the engraving job. The display shows the PM2.5 fine particle level of the surrounding air from 1 to 999 µg/m³ and shows a filter icon when the filters are due for replacement. In the FalconDesignSpace app you can switch the purifier on and off over Wi-Fi, check its status, reset the filter counter and set a delayed shutdown. The app links the Falcon A1 Pro laser engraver to the engraving job, while an engraver connected by the Type-C cable takes priority.


Installation
Place the purifier on a stable table or floor, fit the duct connector to the inlet and connect the exhaust hose between the purifier and the engraver, tightening a clamp at each end. Then connect the power cord and switch on the rocker switch: the lit switch shows that power is on.

Filter replacement and care
When the filter icon appears on the display or in the app, replace both filters at the same time. The first filter comes out after removing the duct connector and the second after releasing the outlet guide panel from its clips; a new filter is seated when it is flush with the housing. The fuse holder of the power switch holds a spare fuse.
In the box
- Air purifier Creality Falcon AP1, 1 pc
- HEPA composite filter and activated carbon filter, fitted in the unit
- Hand-tightened hose clamp, 2 pcs
- Power cord
- Duct connector 65 mm
- Type-C data cable, 2 m
- Exhaust hose, 1.5 m
- User manual






Reviews
There are no reviews yet.