Description
Battery tester for 12 V and 24 V batteries and the charging system
The FNIRSI BTM-24 battery tester shows battery voltage, cranking current, state of charge (SOC), state of health (SOH) and internal resistance in one measurement. It measures voltage from 6 to 30 V.

Battery health test without load
The tester does not load the battery during measurement. You select the battery standard and start the test with one press; the result is a GOOD, CHARGE or BAD rating with the measured values. It supports the CCA, EN, DIN, IEC, JIS and GB standards and AGM batteries with flat and spiral plates, EFB, gel and flooded lead-acid batteries.


Cranking test and charging system check
The cranking test records the voltage drop in real time during engine start and shows whether the voltage stays within the normal range, above 9.6 V. The charging test tracks charging voltage with its minimum and maximum, and a graph shows how voltage changes with engine speed and switched-on loads. From the graph you assess the alternator, voltage regulator and cables. The tester also has a load test.


Display and use in or out of the vehicle
The 2.4-inch colour TFT display has day and night modes. You navigate with direction buttons and an OK button; the menu is in English or Chinese. The battery can be tested in the vehicle or out of it. The tester suits batteries of cars, motorcycles, ATVs, boats, vans, trucks and golf carts.


Protection and build
The unit is protected against reverse polarity, overvoltage and short circuit. Insulated crocodile clips sit on a fixed cable of about 61 cm. The impact-resistant plastic housing has a folding stand and a hanging hole.



In the box
- Battery tester FNIRSI BTM-24, 1 pc
- Test leads with insulated clamps
- Data cable
- Carrying case
- User manual


Reviews
There are no reviews yet.