Description
Wash and cure station for large resin prints
The 15.1-litre wash and cure station Anycubic Wash & Cure 3 Max cleans resin 3D prints and cures them with UV light in one housing. The washing chamber measures 305 × 165 × 300 mm and the basket takes up to 3 kg, up to 1.3 kg on one side. The station suits LCD resin printers with a screen diagonal of up to about 13.6 inches.


Spray washing from every direction
Two symmetrical spray columns with 12 nozzles in total and a rotating basket direct the cleaning fluid onto the model from different directions. After washing the surface, the station separately cleans the bottom of the model and hard-to-reach areas.

Modes and UV curing
The automatic mode combines spraying, soaking and UV curing, and there are separate washing and curing modes. Duration can be set to suit the model size, resin type and desired result. During curing the platform rotates 360° so the UV light reaches the whole surface evenly, and UV power density is up to 25,000 µW/cm² at 18 cm.


Cleaning fluid use
A 25 cm tall model needs about 4 l of solution with spray washing, compared with about 8.5 l when soaking. One 5-litre fill of IPA (isopropyl alcohol) cleans up to 20 such models, on average less than 20 ml per model. A 5-litre cleaning solution container and a second 5-litre container for water or waste water are included.


Operation and monitoring
The touch panel selects the mode and sets the operating parameters, and the lid opens upwards. The station monitors its work and alerts you when fluid is not flowing, the drain or dispenser is blocked, the lid is open or the supply voltage is too low.
In the box
- Wash and cure station Anycubic Wash & Cure 3 Max, 1 pc
- Model basket
- Cleaning solution container, 5 l
- Water and waste water container, 5 l
- Foldable container for used fluid
- Fluid hose, 4 pcs
- Set of wrenches
- User manual
- Power supply with power cord




Reviews
There are no reviews yet.