Brand
Sunlu: 3D printer accessories
- 2% back as bonus points
- 14-day right of return
SUNLU PLA+: tougher parts and even filament
SUNLU PLA+ is reinforced PLA. A part printed from it withstands impacts better than one made from standard PLA and breaks less often. It suits models that have to hold up in use.
The filament flows evenly through the nozzle and rarely clogs it, so even a beginner can finish a model quickly. The filament is wound tightly and neatly. It does not tangle or knot, and the printer can work through the material without interruption.
The diameter variation of PLA+ stays within ±0.02 mm. An even thickness gives an even feed, and the filament suits many FDM printers.
SUNLU PLA and PETG in different finishes
All SUNLU products are in our category Filaments. PLA filaments are 1.75 mm in diameter and are sold by the 1 kg roll. Side by side are PLA Classic, PLA+ and PLA+ 2.0.
There is also a choice by finish. PLA Matte and PETG High Speed Matte give the part a matte surface. Silk PLA+ gives the part a silky sheen. With transparent PLA+ filament you can print parts that let light through.
The basic colours available are white, black and grey. Brighter colours include red and yellow, for example.
Printing and storing SUNLU filament
Before buying, check which filament diameter your printer uses. Our SUNLU PLA filaments are 1.75 mm, the most common size in FDM printers.
The manufacturer recommends printing PLA+ at a nozzle temperature of 205-215 °C when the speed is 50-100 mm/s. For faster printing, at 100-200 mm/s, raise the temperature to the range 215-245 °C. The print bed should be at 50-60 °C. Ready-made settings for many printers can be found in the Printer Presets section of the SUNLU website.
Filament absorbs moisture from the air, and damp filament prints worse. Keep opened filament in a dry place, ideally in an airtight box with a desiccant.
Frequently asked
PLA+ is reinforced and tougher PLA. A part printed from it withstands impacts better and breaks less often than a part made from standard PLA.
The SUNLU PLA filaments in our range are 1.75 mm in diameter. For PLA+ the variation stays within ±0.02 mm, so it suits many FDM printers.
The manufacturer recommends a nozzle temperature of 205-215 °C at 50-100 mm/s and 215-245 °C at 100-200 mm/s. The print bed should be at 50-60 °C.
Yes, SUNLU PLA+ flows evenly and rarely clogs the nozzle. Neatly wound filament does not knot, so even your first model can be finished with little effort.
The SUNLU website has a Printer Presets section. There you can find ready-made settings for many printers to use in your slicing software.
-
43,95 €
- Product type
- Filament dryer
-
48,95 €
- Product type
- Filament dryer
-
133,95 €
- Product type
- Filament dryer
-
389,95 €
- Product type
- Filament dryer
-
126,95 €
- Product type
- Filament dryer
All products shown.