Description
Tyre inflator for large tyres and inflatable gear
The twin-cylinder Etenwolf S6 cordless tyre inflator from the Vortex series inflates the tyres of pickups, off-roaders, motorhomes, cars, motorcycles and bicycles. According to the manufacturer, one full charge raises the pressure of up to 18 pickup tyres (245/70 R17) from 30 to 35 psi.

High-pressure hose and high-volume hose
The high-pressure hose takes the tapered nozzle, the ball needle and the Presta valve adapter for bicycles, all stored on the back panel. The high-volume hose inflates mattresses, mats and inflatable boats, and in deflation mode it pumps the air out of them.

Modes and automatic stop
The MODE button selects six inflation modes and a deflation mode, and the UNIT button switches between psi, kPa and bar. You set the target pressure with the rotary knob, and the display shows target and actual pressure together. The pump stops by itself at the target pressure and remembers the last pressure and unit.
| Mode | Pressure range | Default |
|---|---|---|
| Car | 8–50 psi | 35 psi |
| Pickup | 10–85 psi | 35 psi |
| Motorhome | 20–130 psi | 60 psi |
| Bicycle | 10–145 psi | 22 psi |
| Ball | 3–16 psi | 8.5 psi |
| Manual | up to 11 bar (160 PSI) | 30 psi |
Battery, charging and power bank
The battery stores 71 Wh and charges through the USB-C port with 45 W USB PD charging. The same USB-C port provides a power bank output of up to 45 W, and there is also a USB-A output for charging a phone, tablet, camera or laptop straight from the pump. The pump also has a 12 V external power socket.



LED light and cooling
The LED light on the side of the handle gives 300 lm or 1000 lm and also has slow strobe and an SOS signal for emergencies. According to the manufacturer, the cooling system lets the pump run continuously without breaks.

Use
- Switch the pump on by holding the START/PAUSE button for 1 second.
- Connect the high-pressure hose to the valve and select a mode with the MODE button.
- Turn the knob to the required target pressure and press START/PAUSE again to inflate.
Cleaning and care
Use the pump in a dry, clean place and do not wash it with water. In longer storage, charge the battery every three months and keep the pump at –20 °C to 60 °C.
In the box
- Tyre inflator Etenwolf S6, 1 pc
- High-pressure hose, 1 pc
- High-volume hose, 1 pc
- Air chuck, 1 pc
- Tapered nozzle, 1 pc
- Ball needle, 1 pc
- Presta valve adapter, 1 pc
- 45 W USB PD charger, 1 pc
- USB-C cable 1.8 m, 1 pc
- Carry bag, 1 pc
- User manual, 1 pc


Reviews
There are no reviews yet.