Description
Cordless tyre inflator with jump starter for tyres and flat car batteries
The cordless tyre inflator Etenwolf X6 Pro Max reaches up to 11 bar (160 PSI), delivers 30 l/min of air and has a 12,000 mAh battery. Tyre inflation and jump starting in one device, with the display showing target and actual pressure together.

Four inflation modes with preset pressure
The M button selects car, ball, bicycle or manual mode: car mode sets 8–130 PSI, bicycle mode 10–145 PSI, ball mode 3–16 PSI and manual mode 3–160 PSI. When the set pressure is reached, the pump stops automatically. A long press of M switches between bar, psi and kPa, and the device remembers the last target pressure. The pressure sensor is accurate to ±1 PSI.
Use
Hold the power button for 0.5 seconds to switch on, pull the high-pressure hose out from the side and screw its nozzle clockwise onto the valve. Choose a mode, set the target with + and − and start inflating with a short press of the power button. The ball needle, Presta valve adapter and cone nozzle are stored in the rear compartment. According to the manufacturer, a full battery runs the pump for about 20 minutes at 25 °C within 20–50 PSI. The LED light on top of the pump offers high brightness, red flashing and an SOS signal.
Jump starting a car with a flat battery
In jump start mode, plug the smart battery clamp cable into the DC output, connect the red clamp to the battery positive and the black clamp to the negative. When the green READY light is on, start the car with the key or remote and remove the clamps, ideally within 30 seconds. With a very low battery, holding the side button on the clamp for 5 seconds activates forced start.

Charging and power bank
The battery charges through the USB-C PD 3.0 port at 30 W, from empty to full in about 2 hours. The same port is a 30 W power bank output for a phone, tablet, laptop, drone or camera. A four-bar indicator shows the charge in 25% steps.
Storage and care
Store the device at −20 to 60 °C and use it in a dry and clean place. Above 1,524 m you can recalibrate the pressure sensor by holding the light button and the M button together for 10 seconds.
In the box
- Tyre inflator Etenwolf X6 Pro Max, 1 pc
- Smart battery clamp cable, 1 pc
- USB-C to USB-C cable, 1 pc
- Ball needle, Presta valve adapter and cone nozzle
- User manual, 1 pc

Reviews
There are no reviews yet.