Description
Undermount stainless steel sink BLANCO SUPRA 400-U
The undermount stainless steel sink BLANCO SUPRA 400-U is fixed from below into the worktop cut-out, so the sink rim sits under the worktop. The surface is brushed, the outer size is 430 × 430 mm and the height 184 mm. The sink has one bowl with a 60 mm corner radius.
Installation under the worktop
The sink suits a dense, water-resistant worktop such as natural stone, glass or composite. Wood and wood-based boards are unsuitable for an undermount sink. The worktop cut-out is 400 × 400 mm with a tolerance of +2/−1 mm and a 60 mm corner radius.
For screw fixing, four holes 5 mm in diameter and 13 mm deep are drilled into the worktop 22 mm from the cut-out edge, and the fixing screws are tightened with a PZ 2 screwdriver. Before fitting, the underside of the worktop is cleaned with isopropanol and silicone is applied to the sink rim. Once the excess silicone is removed, wait 24 hours before using the sink.
The tap is fitted into the worktop: a 35 mm hole is made 60 mm from the cut-out edge. According to the side-view drawing, the drain outlet sits 285 mm below the top of the worktop.
Bowl, drain and overflow
The bowl has a 3½″ basket strainer that is opened and closed by hand, and an overflow in its back wall. The space-saving pipe of the waste kit runs the drain towards the back of the cabinet, leaving free space under the sink. BLANCO recommends this pipe when a pull-out waste sorter is fitted in the sink cabinet. The dishwasher drain hose connects to the dishwasher connection of the trap.
Stainless steel and surface finish
The sink is made of 18/10 stainless steel, which contains 18% chromium and 10% nickel. Together with oxygen, the chromium forms a thin, invisible protective layer that renews itself. The first fine scratches on a new sink are normal, and many become less visible within a few days as the layer renews.
The surface is brushed and its tone stays the same under a hot pot and long sunlight. Reddish spots on the surface are rust carried over from other rusty objects or from the water pipes, and they wipe off.
Stainless steel sink care
For daily cleaning, put a little washing-up liquid on the soft side of a sponge and wipe along the brushing direction, avoiding circular movements. Then rinse the sink and dry it with a microfibre cloth. To remove limescale, use a descaler or vinegar essence diluted with ten parts water.
Once a month, give the sink a thorough clean with a stainless steel cleaner: apply a hazelnut-sized amount with a sponge and polish along the brushing direction. To clean the basket strainer, put a level teaspoon of dishwasher powder on the closed strainer, pour over about 250 ml of boiling water and let it work. Then brush the strainer clean and rinse.
Unsuitable for cleaning a stainless steel sink are abrasive cleaners, hypochlorite bleach, silver cleaning baths, scratchy brushes and sponges, steel wool and cleaners containing chlorine or hydrochloric acid. Strong salt solutions should not stay on the surface for long.
In the box
- Kitchen sink BLANCO SUPRA 400-U, 1 pc
- Waste and overflow kit with space-saving pipe
- 3½″ basket strainer, opened by hand
- Fixing kit
Needed separately
One trap is needed to connect the sink to the drain: Kitchen sink trap BLANCO 137267 connects the waste kit to a Ø40 or Ø50 mm pipe and has a dishwasher connection. With a waste sorter under the sink, the flat trap BLANCO 137287 with a Ø50 mm outlet and two appliance connections fits. The kitchen tap is bought separately too.






Reviews
There are no reviews yet.