Description
Hose timer with two dials for setting duration and frequency
The RainPoint ITV152 hose timer is a single-zone timer for a garden tap, controlled by two dials and a manual watering button. The left dial sets the watering duration and the right dial the frequency, so the schedule is set with two turns.


Automatic watering options on the duration and frequency dials
The duration dial has positions for 1, 3, 5, 10, 15, 20, 30, 45, 60, 90 and 120 minutes and OFF. The frequency dial waters every 1, 2, 3, 4, 6, 8, 12, 24, 48 or 72 hours or once a week, and in the ONE/OFF position the timer runs a single watering. A green light confirms the setting by flashing five times and then staying on for two seconds.

Manual watering
A short press of the button opens the valve and a second press closes it, so you can water outside the schedule. During manual watering the green light flashes every five seconds. When the batteries run low, a red light comes on and the timer closes the valve at once.


Installation
The battery compartment on the back takes two new 1.5 V AAA alkaline batteries. Turn off the garden tap, wrap sealing tape around the tap thread and screw the timer onto the tap by hand, with the dials as upright as possible. Then wrap tape around the outlet thread, screw on the 3/4″ garden hose and turn the tap on after programming. The timer fits a tap with a BSP 3/4″ or 1″ thread and works at a water pressure of 0.5–8 bar.

Cleaning and care
Turn off the tap, remove the timer and rinse the inlet filter under running water. With the valve opened by the manual watering button you can clean the water channel with a small brush. IP55 means protection against dust and water jets from any direction; the timer works at 3–50 °C and should be stored indoors before frost.
In the box
- RainPoint ITV152 hose timer, 1 pc
- User manual
- Sealing tape
- Spare rubber washer


Reviews
There are no reviews yet.