Description
Irrigation controller runs 12 zones on three programs
The 12-zone irrigation controller RainPoint ITC1200 runs the solenoid valves of a garden watering system, and you set the whole schedule with the dial, buttons and LCD display. Each zone gets its own watering time, and three separate programs allow different schedules for lawn and beds.

Start times and frequency of the watering automation
Each program has up to four start times, and the run time per zone is 0–240 minutes. You set the frequency by days of the week, an interval of 1–30 days, or odd and even dates. The manual watering button opens a zone at once and leaves the stored schedule unchanged.

Seasonal adjustment and rain delay
Seasonal adjustment changes the watering time for each month separately from 10% to 200% in 10% steps: at 150%, a 10-minute run lasts 15 minutes. Manual rain delay pauses the schedule for up to 30 days. The normally closed rain sensor, which opens its contact when it rains, can be switched on or off for each zone separately.

Compatible valves and power
The controller works with 24 V AC solenoid valves with a holding current below 200 mA and with 24 V AC motor valves; a master valve connects to terminals C and M. It runs on 230 V mains power, and a CR2032 battery keeps the schedule in memory during a power cut.
Installation
The controller hangs on an upper screw on the wall and is fixed at the bottom with a second screw through the mounting hole; use the supplied wall plugs where needed. One wire of each valve goes to its zone terminal and the other to the common terminal C. The two rain sensor wires connect to the SENSOR terminals once the shorting jumper is removed. The controller cover opens with a key.

In the box
- Irrigation controller RainPoint ITC1200, 1 pc
- Screws and wall plugs, 4 pcs
- Quick guide
- User manual



Reviews
There are no reviews yet.