Description
Kitchen mixer tap with two-mode pull-out spray BLANCO CATRIS-S
The kitchen mixer tap with two-mode pull-out spray BLANCO CATRIS-S is a semi-professional tap whose flexible spout is held by a stainless steel spring. The spray is easily taken out of its holder and moved freely within the reach of the spout. The brass body is galvanically chrome-plated, finish chrome.
Spray, jets and flow
The spray has two switchable jets: an aerated jet and a spray jet. The tap is 476 mm high in total and the spout reaches 187 mm. BLANCO considers CATRIS-S particularly suited to kitchens with wall units. The maximum flow at 3 bar is 8.35 l/min. The spray hose is metal-sheathed and the lever sits on the right of the body.
Installation and water pressure
The tap fits a 35 mm hole in the sink or worktop, and the mounting surface may be up to 50 mm thick. The base diameter is 54 mm. It connects to the supply with flexible 700 mm hoses with a ⅜″ nut. In a stainless steel sink, put the stabilising plate under the tap for firmer support. The non-return valve (EN 1717) in the box stops water flowing back into the mains.
A high-pressure tap fits when the kitchen has both a cold and a hot water wall valve and the water is heated centrally or by an instantaneous water heater. An open boiler under the sink needs a low-pressure tap (ND), which has three hoses. A high-pressure tap connects only to a pressurised supply, because its number of hoses differs from a low-pressure tap. The tap withstands water pressure up to 10 bar and hot water up to 70 °C.
The tap is fixed from below with a clamp whose screws are tightened with a PZ2 screwdriver. Before connecting the hoses, flush the pipes by opening the angle valves over a bucket, then connect the hoses with a 19 mm spanner. Finally remove the spray aerator, let the water run for at least 20 seconds, refit the aerator and check the spray, body and angle valve joints for leaks.
Tap care
A microfibre cloth suits drying the chrome surface after use. To remove limescale, use a vinegar- or citric-acid-based descaler and keep to its contact time. Chlorine cleaners and the rough side of a sponge damage the chrome surface, so clean the tap with a soft cloth or sponge.
A hard aerator can be unscrewed anticlockwise and left overnight in vinegar water or citric acid. BLANCO states that spare parts for its taps are available for at least 10 years.
In the box
- Kitchen mixer tap BLANCO CATRIS-S, 1 pc
- Flexible connection hoses, 700 mm, with ⅜″ nut
- Stabilising plate for installing the tap in a stainless steel sink
- Non-return valve (EN 1717)
Needed separately
To connect the hoses you need cold and hot water angle valves under the sink. For old pipes BLANCO recommends a dirt filter between the angle valve and the connection hose.






Reviews
There are no reviews yet.