Description
Filter kitchen tap BLANCO CATRIS-S Flexo
The filter kitchen tap BLANCO CATRIS-S Flexo is a 3-in-1 tap that gives you both mains water and filtered drinking water from one body. The colour is black matt and the body is brass. In BLANCO’s semi-professional design the spout is a flexible hose and the spray head docks magnetically onto its holder. As a high-pressure tap it suits a kitchen where both the cold and the hot water pipe come out of the wall.
Filtered water from its own handle
The right lever mixes cold and warm water; the left handle opens the filtered drinking water. Filtered water runs in its own channel inside the tap, so it does not mix with mains water. Because all three types of water come from one tap, one 35 mm hole is enough.
According to BLANCO the tap works with all common water filter systems. Only cold water is fed into the BLANCO water filter system: cold water at the filter inlet 4–30 °C. Hot water entering the tap may be up to 70 °C. On first use, run at least 10 l through the filtered-water line and hold the left handle open for at least 20 seconds.
Spout, spray and flow
The spout reach is 186 mm and the total height of the tap is 467 mm. The flow rate at 3 bar is 7.68 l/min. The two-mode pull-out spray switches between an aerated stream and a powerful rinse spray. A flow-stop button on the spray pauses the water. The plastic spray head docks back onto its holder magnetically, and the hose is covered in black silicone.
Installation and water pressure
The tap fits a 35 mm hole and connects with 700 mm flexible hoses with a ⅜″ nut. When fitted into a stainless steel sink, the supplied stabilising plate holds the tap firmly. Tightening the nuts needs a 19 mm spanner and pliers. Flush the water pipes into a bucket before connecting the tap; after connecting, unscrew the aerator and let the water run. Then let the water run for 10 minutes and check the connections. BLANCO recommends having the water filter system installed by a specialist.
A high-pressure (HD) tap suits a kitchen with wall valves for both cold and hot water, for example with central hot water or an instantaneous water heater. An open boiler under the sink needs a low-pressure (ND) tap with three hoses. A low-pressure connection takes a low-pressure tap again, because the number of hoses differs. The tap withstands water pressure up to 10 bar, and the water filter system works at 2–8 bar. The non-return valve (EN 1717) prevents backflow into the mains.
Finish and sink colour
The brass body has a black matt finish. The spray hose and spray head are black too, so the whole tap is one colour.
Tap care
Wipe the tap with the soft side of a sponge and dry it with a microfibre cloth. On the matt surface use only chlorine-free cleaners and the soft side of the sponge. If the stream starts to splash, unscrew the aerator anticlockwise and soak it overnight in vinegar water or citric acid.
The pull-out hose is made for constant movement, so take care not to kink it. If the hose no longer glides back smoothly, apply tap grease. For old water pipes BLANCO recommends a dirt filter between the angle valve and the connecting hose. According to BLANCO, spare parts for the tap are available for at least 10 years.
In the box
- Kitchen mixer tap BLANCO CATRIS-S Flexo, 1 pc
- Stabilising plate for fitting the tap into a stainless steel sink
Needed separately
For filtered drinking water from this filter tap you need a BLANCO water filter system. It goes under the sink and connects to the tap’s filtered-water hose.




Reviews
There are no reviews yet.