Description
Kitchen mixer tap with two-mode pull-out spray BLANCO CULINA-S II Mini
The kitchen mixer tap with two-mode pull-out spray BLANCO CULINA-S II Mini is a semi-professional single-lever tap in PVD steel. As a high-pressure tap (HD) it suits kitchens where both the cold and the hot water pipes come out of the wall. The lever sits on the right of the tap.
Spray, jets and flow rate
The Mini version is 448 mm high overall and, according to BLANCO, suits kitchen wall units well. The spout reaches 205 mm. A button on the spray switches between a clear stream and a powerful shower spray, and the flow stop on the spray pauses the water without moving the lever. The metal-sheathed spray hose and the spray can be taken out of the holder and directed to any part of the sink; when put back, the hidden magnet holds the spray in place. At 3 bar the flow rate is 8.9 l/min. The spout ends in a clear-jet aerator.
Installation and water pressure
The hole in the sink or worktop must be 35 mm in diameter and the mounting surface may be up to 51 mm thick. When fitting the tap to a stainless steel sink, place the supplied stabilising plate under it. The tap works at a mains pressure of up to 10 bar and with hot water up to 70 °C and has a non-return valve to EN 1717. An open boiler under the sink needs a low-pressure tap (ND) with three connection hoses, and only another low-pressure tap can replace a low-pressure tap.
With the BLANCOLock fixing, the tap is fixed from below with a plastic nut tightened with pliers. Flush the angle valves into a bucket and connect the 950 mm connection hoses to the angle valves with a 19 mm spanner without twisting them. Then remove the aerator, let the water run for at least 20 seconds, check the connections for leaks and refit the aerator.
PVD finish and matching sink
The steel colour is a PVD coating on the brass body, a thin metal layer vapour-deposited in a vacuum. BLANCO matches its PVD steel taps with all its stainless steel sinks, especially those with a satin polish finish. The tap weighs 2.38 kg.
Tap care
After use, wipe the tap dry with a microfibre cloth; the BLANCO microfibre cloth 126999 suits all surfaces. To remove limescale, spray BLANCO DailyClean+ (526305) on the surface, leave it for a moment, wipe with a damp cloth and dry, but test it on a hidden spot first. Chlorine cleaners and the scouring side of a sponge damage the PVD surface, so use a soft cloth.
If the aerator is hard with limescale, unscrew it and soak it overnight in vinegar water or citric acid. For old water pipes BLANCO recommends a dirt filter between the angle valve and the connection hose. BLANCO states that spare parts for its taps are available for at least 10 years.
In the box
- Flexible connection hoses, 950 mm, with ⅜″ nut
- Stabilising plate for fitting the tap to a stainless steel sink




Reviews
There are no reviews yet.