Description
Filter kitchen tap BLANCO FONTAS-S II
Filter kitchen tap BLANCO FONTAS-S II is a tap with an L-shaped spout whose pull-out spray delivers both mains water and filtered drinking water. The colour is PVD steel. The spray head has two outlets side by side: one for mains water and one for filtered water.
Filtered water from its own handle
The tap is a 3-in-1 solution: cold, warm and filtered water come from one tap. The lever on the right mixes cold and warm water; the rotary handle on the left opens the filtered water. Filtered water runs in its own channel and leaves the spray through its own outlet, so it stays separate from mains water.
One hole is enough for filtered water as well, because all three come from the same tap. The water filter system runs on cold water: cold water at the filter inlet 4–30 °C. Before first use, unscrew the aerators, run at least 10 l of filtered water and mixed water for at least 20 seconds, then refit the aerators.
Spout, spray and flow
The spout reach is 216 mm and the overall height 306 mm. The flow rate at 3 bar is 7.7 l/min. An aerator in the spray head mixes air into the jet, giving an even, soft jet.
The metal pull-out part of the spray runs on a nylon-sheathed hose. A weight clipped to the hose in the sink cabinet pulls the spray back into the spout after use.
Installation and water pressure
The tap fits a 35 mm hole in the sink or worktop, with a mounting surface up to 59 mm thick. It connects to the angle valves with 500 mm flexible hoses with a ⅜″ nut: the red hose to the hot and the blue to the cold valve. The hose marked FILTER connects to the water filter system, with a tightening torque of up to 15 Nm on the filter head.
In a stainless steel sink, the supplied stabilising plate keeps the tap steady. The supplied non-return valve to EN 1717 keeps water from the tap from flowing back into the supply pipes. After installation, let the water run for 10 minutes and check that the connections are tight.
FONTAS-S II is a high-pressure (HD) tap working at a mains pressure of 2–8 bar, with hot water up to 70 °C. A high-pressure tap suits a kitchen where both cold and hot water come from pipes in the wall, including homes with an instantaneous water heater. An open, unvented boiler under the sink needs a low-pressure (ND) tap with three hoses, and because the number of hoses differs, a high-pressure tap does not fit a low-pressure connection.
Finish and matching sink
The body is brass with a steel-coloured PVD finish. BLANCO matches the PVD steel colour to its stainless steel sinks, so the tap suits a stainless sink, especially one with a satin polish finish.
Tap care
After use, dry the tap with a soft microfibre cloth. Remove limescale with a mild vinegar or citric acid solution or a descaler, then rinse with clean water. If the aerator is hard with limescale, unscrew it anticlockwise and soak it overnight in vinegar water or citric acid.
Keep the spray hose in the sink cabinet free of kinks. If the hose no longer glides back smoothly, apply a little tap grease. In houses with old water pipes, BLANCO recommends fitting a dirt filter between the angle valve and the tap hose. According to BLANCO, spare parts for its taps are available for at least 10 years.
In the box
- Kitchen mixer tap BLANCO FONTAS-S II, 1 pc
- Weight that pulls the spray hose back
- Flexible connection hoses, 500 mm, with ⅜″ nut
- Stabilising plate for installation in a stainless steel sink
- Non-return valve (EN 1717)
Needed separately
For filtered drinking water, the tap must be connected to a BLANCO water filter system, bought separately.




Reviews
There are no reviews yet.