Description
Smart input module for controlling Z-Wave scenes from an ordinary switch
The Shelly Wave i4 DC smart input module is a four-input Z-Wave module mounted in a flush wall box. It reads presses of four switches or push-buttons and sends commands to other devices on the Z-Wave network.

Four inputs and Multi-Click with up to 16 actions
Each input works in push-button or toggle mode, so a multi-gang switch controls different scenes. Multi-Click lets you assign up to 16 actions to press combinations. The module monitors the input status and supports the Central Scene command class, through which the Z-Wave hub runs a scene on a press.

Z-Wave Long Range reaches 80 metres indoors
The module has a Z-Wave 800 series S800 processor. In a standard mesh network at 868.4 MHz the indoor range is up to 40 m and the module also acts as a signal repeater. In Long Range mode at 864 MHz it talks directly to the hub, with a range of up to 80 m indoors and up to 1000 m outdoors.

SmartStart and S2 security
SmartStart adds the module to the Z-Wave network by scanning a QR code. Communication is protected with S2 authentication and AES-128 encryption. Firmware updates arrive over the air (OTA) without removing the module from the wall, and the module has overheat protection.

Installation in the wall box behind the switch
Measuring 37 × 42 × 16 mm, the module fits in the wall box behind the switch. It needs a 5–24 V DC supply and draws less than 0.3 W. The terminals take wire of 0.5–1.5 mm² cross-section, stripped to 5–6 mm, and the terminal screw torque is up to 0.4 Nm.

In the box
- Smart input module Shelly Wave i4 DC, 1 pc


Reviews
There are no reviews yet.